Beko EV 7100+ - Installation Procedures; Compliance and Installation Overview; Installation Steps

4 / EN
Washing Machine / User’s Manual
1.6 Compliance with WEEE Directive
ThisproductcomplieswithEUWEEEDirective(2012/19/EU).Thisproduct
bearsaclassificationsymbolforwasteelectricalandelectronicequipment
(WEEE).
Thisproducthasbeenmanufacturedwithhighqualitypartsandmaterials
whichcanbereusedandaresuitableforrecycling.Donotdisposeofthe
waste product with normal domestic and other wastes at the end of its servi-
ce life. Take it to the collection center for the recycling of electrical and elec-
tronicequipment.Pleaseconsultyourlocalauthoritiestolearnaboutthese
collection centers.
Compliance with RoHS Directive:
TheproductyouhavepurchasedcomplieswithEURoHSDirective(2011/65/EU).It
doesnotcontainharmfulandprohibitedmaterialsspecifiedintheDirective.
2 Installation
Refer to the nearest Authorised Service Agent for installation
of the product. To make the product ready for use, review
the information in the user manual and make sure that the
electricity, tap water supply and water drainage systems are
appropriatebeforecallingtheAuthorizedServiceAgent.Ifthey
arenot,callaqualifiedtechnicianandplumbertohaveany
necessary arrangements carried out.
C
INFORMATIONS
Preparationofthelocationandelectrical,tapwaterandwaste
water installations at the place of installation is under customer’s
responsibility.
Make sure that the water inlet and discharge hoses as well as the
powercablearenotfolded,pinchedorcrushedwhilepushingthe
product into its place after installation or cleaning procedures.
B WARNING
Installationandelectricalconnectionsoftheproductmustbe
carriedoutbytheAuthorizedServiceAgent.Manufacturershallnot
beheldliablefordamagesthatmayarisefromprocedurescarried
outbyunauthorizedpersons.
A WARNING
Priortoinstallation,visuallycheckiftheproducthasanydefectson
it.Ifso,donothaveitinstalled.Damagedproductscauserisksfor
your safety.
2.1 Appropriate installation location
• Placethemachineonarigidfloor.Donotplaceitonalong
pile rug or similar surfaces.
• Totalweightofthewashingmachineandthedryer-with
full load- when they are placed on top of each other
reachestoapprox.180kilograms.Placetheproductona
solid and flat floor that has sufficient load carrying capacity!
• Donotplacetheproductonthepowercable.
• Donotinstalltheproductatplaceswheretemperaturemay
fallbelow0ºC.
• Placetheproductatleast1cmawayfromtheedgesof
other furniture.
2.2 Removing packaging reinforcement
Tiltthemachinebackwardstoremovethepackaging
reinforcement.Removethepackagingreinforcementby
pullingtheribbon.
2.3 Removing the transportation locks
A WARNING
Donotremovethetransportationlocksbeforetakingoutthe
packaging reinforcement.
Removethetransportationsafetyboltsbeforeoperatingthe
washingmachine!Otherwise,theproductwillbedamaged.
Loosenalltheboltswithasuitablespanneruntiltheyrotate
freely(C).Removetransportationsafetyboltsbyturningthem
gently.AttachtheplasticcoverssuppliedintheUserManual
bagintotheholesontherearpanel.(P)
C
INFORMATIONS
Keepthetransportationsafetyboltsinasafeplacetoreusewhen
thewashingmachineneedstobemovedagaininthefuture.
Nevermovetheproductwithoutthetransportationsafetybolts
properlyfixedinplace!