Why Beko SPA7131P soleplate does not heat up?
If the soleplate (3) of your Beko Iron isn't heating up even when plugged in, the appliance may be connected improperly. Check the plug and power cable (1) of the appliance.
Why does my Beko Iron leave sediments during ironing?
If sediments and residues fall from the Beko Iron's soleplate during ironing, it may be due to hard water usage. Use the self-clean function once or a few times. For subsequent ironing, fill the water reservoir with a mixture of tap water and potable water.
Why does my Beko SPA7131P leak water after use?
If your Beko Iron drops water after it cools down or is stored, it may be because the appliance was left on a horizontal position with water in the reservoir. Empty the water reservoir to prevent this.
Covers essential safety guidelines for using the appliance, including usage by children and unattended operation.
Details product compliance with the WEEE Directive and instructions for environmentally sound disposal of electrical waste.
Explains the appliance's plug wiring, including fuse replacement and correct connection of wires to terminals.
Explains how to perform steam ironing, including using the steam trigger and the anti-drip sensor function.
Describes the use of the powerful shock steam function for removing stubborn creases, with important warnings.
Details the self-clean function for removing limescale buildup from the steam generator reservoir.
To Next Page
General
