Why is my Beko Iron leaking water during ironing?
If your Beko Iron is leaking water onto the fabric while ironing, it might be because the water refill lid (5) is not securely closed. Make sure to close the water refill lid tightly before ironing.
What to do if my Beko SPA7131P Iron doesn't generate steam?
If your Beko Iron is not generating steam, the water reservoir may be low. Fill the water reservoir with water up to the Max level.
What to do if my Beko SPA7131P leaks water while ironing?
If water drops fall onto the fabric during ironing with your Beko Iron, ensure that you securely close the water refill lid.
What to do if my Beko SPA7131P is not generating steam?
If your Beko Iron isn't generating steam, the water reservoir may not have enough water. Fill the water reservoir with water up to the Max level (see. 3.3).
What to do if sediments fall from my Beko SPA7131P during ironing?
If sediments and residues are falling from the soleplate (3) of your Beko Iron during ironing, it may be due to using hard water. Use the self-clean function for once or a few times (see. 4.2). For subsequent ironings, fill the water reservoir with a mixture of tap water and potable water.
How to clean stains on my Beko SPA7131P Iron soleplate?
If the soleplate of your Beko Iron has stains, it may be due to ironing wet garments or lime stains. After the appliance cools, wipe the soleplate with a microfiber knitted or cotton cloth soaked in vinegar.
Why is my Beko SPA7131P not heating up?
Check the plug and power cable of your Beko Iron.
Why does my Beko SPA7131P leave stains on the soleplate?
Stains on the soleplate (3) of your Beko Iron may appear if wet garments have been ironed or if the soleplate has lime stains. After the appliance cools down, wipe the soleplate with a microfiber knitted or cotton cloth soaked in vinegar.
Why does my Beko SPA7131P leak water after cooling down?
If your Beko Iron is leaking water after it cools down or is stored, it's probably because you left the appliance on a horizontal position while there was still water in its reservoir. Empty the water reservoir after each use to prevent this.
How to fix Beko SPA7131P Iron Shock Steam that is not working?
If the Shock Steam – Vertical Steam function of your Beko Iron is not working, it may be because these functions have been used too frequently in a short period. Keep ironing at a horizontal position and wait for a while before using the shock steam function again. Also, the soleplate (3) might not be hot enough, in this case, seat the appliance in a vertical position and wait for the soleplate to heat up.
Covers essential safety guidelines for using the appliance, including usage by children and unattended operation.
Details product compliance with the WEEE Directive and instructions for environmentally sound disposal of electrical waste.
Explains the appliance's plug wiring, including fuse replacement and correct connection of wires to terminals.
Explains how to perform steam ironing, including using the steam trigger and the anti-drip sensor function.
Describes the use of the powerful shock steam function for removing stubborn creases, with important warnings.
Details the self-clean function for removing limescale buildup from the steam generator reservoir.
To Next Page
General
