What to do if the Beko Washer programme cannot be started or selected?
The product may have switched to self-protection mode due to a supply problem (line voltage, water pressure, etc.). Press and hold the On / Off button for 3 seconds to reset the product to factory settings.
Why Beko WB 963446B Washer is not taking water in?
If your Beko Washer isn't taking water, several issues could be the cause. First, check if the tap is turned off and turn it on. Next, inspect the water inlet hose for any bends or crushing and reposition the hose if needed. Also, the water inlet filter might be clogged, so clean the filter. Finally, ensure that the loading door is properly closed.
How to open the loading door of my Beko WB 963446B?
If the loading door of your Beko Washer cannot be opened, it might be because the cover lock is activated due to the water level inside the product. To resolve this, drain the water by running the Pump or Spin program. Alternatively, the product might be heating up the water or is at the spinning cycle, so wait until the program completes. Lastly, the child lock might be engaged, so wait a couple of minutes for deactivation of the door lock after the program has ended.
Why is my Beko WB 963446B Washer leaking water from the bottom?
If water is leaking from the bottom of your Beko Washer, the water drain hose might be clogged or twisted, so clean or reposition the hose. Alternatively, the pump filter could be clogged, so clean the pump filter.
Why doesn't my Beko WB 963446B Washer switch to the spinning step?
Your Beko Washer might not switch to the spinning step due to an unbalanced load. The automatic unbalanced load detection system might be activated because of this. Also, the product won't spin if water isn't completely drained, so check the filter and the draining hose. Excessive foam might also be the cause, so use the recommended amount of detergent.
How to start Beko Washer programme after closing the door?
Press the Start / Pause / Cancel button.
What to do if foam is overflowing from the detergent drawer of my Beko WB 963446B Washer?
If foam is overflowing from the detergent drawer of your Beko Washer, it's likely that too much detergent is used. Mix 1 tablespoonful of softener with ½ liter of water and pour it into the main wash compartment of the detergent drawer. Also, put detergent into the product suitable for the programmes and maximum loads indicated in the manual. When you use additional chemicals (stain removers, bleaches, etc.), reduce the amount of detergent.
Why does my Beko Washer directly discharge the water it takes in?
The draining hose might not be at adequate height. Connect the water draining hose as described in the operation manual.
Why is my laundry turning grey after washing in my Beko WB 963446B?
If your laundry turns grey after washing in your Beko Washer, it could be due to using an insufficient amount of detergent over a long period, or washing at low temperatures for a long time. Also, using insufficient detergent with hard water can cause greying. In some cases, using an excessive amount of detergent can also contribute to this issue. Use the recommended amount of detergent appropriate for water hardness and the laundry.
Why too much foam forms inside my Beko WB 963446B Washer?
Excessive foam inside your Beko Washer can occur if you're using improper detergents for the washing machine, or using too much detergent. It can also happen if the detergent was stored improperly, or if you are washing meshed laundry such as tulle. Ensure you are putting the detergent in the correct compartment. The softener may also be taken early by the product, which indicates a problem in the valves or detergent dispenser.
Essential safety guidelines to prevent injuries and property damage.
Safety measures and precautions for children using the appliance.
Guidelines for safe electrical connection and usage to prevent shock.
Warnings about hot surfaces and keeping children away.
Details on WEEE directive compliance for waste electrical equipment.
Information regarding the recyclability of packaging materials.
Identifies the main parts of the washing machine through a diagram.
Lists all items included in the product packaging.
Provides detailed technical data and specifications of the appliance.
Recommendations for placing the machine on a suitable, stable surface.
Steps to remove transport packaging and reinforcement before use.
Guide to safely remove transit bolts to prevent machine damage.
Instructions for connecting the water inlet hoses to the appliance.
Guidance on properly connecting the drain hose for effective water discharge.
Steps to ensure the machine is level and stable for quiet operation.
Instructions for safe electrical connection to the mains supply.
Preparations and initial run steps before first use with laundry.
Guidance on sorting clothes by fabric, colour, and soil level.
Tips for preparing clothes, such as closing zippers and using laundry bags.
Advice on economical and energy-efficient washing practices.
Instructions on how to properly load the washing machine drum.
Information on maximum load capacity and its impact on performance.
Guidance on selecting and adding detergent and softener.
Advice on selecting appropriate detergent based on fabric and colour.
How to determine the correct amount of detergent for optimal results.
Instructions for using fabric softener in the designated compartment.
Specific instructions for using liquid detergents, with or without a cup.
How to use gel and tablet detergents in the machine.
Instructions for using starch as a laundry additive.
When and how to use limescale removers.
Guidelines for safely using bleaching agents.
Practical tips for achieving efficient and effective laundry washing.
Overview and identification of all controls and indicators on the panel.
Details of available wash programmes, their settings, and consumption.
How to choose the most suitable wash programme for your laundry.
Descriptions of various wash programmes available on the machine.
How to adjust the wash temperature for selected programmes.
How to select and adjust the spin speed for laundry.
How to select and use additional wash functions.
How to set a delayed start time for wash programmes.
Steps to initiate a wash cycle.
Explanation of the door locking mechanism during operation.
How to modify settings while a programme is running.
How to activate and deactivate the child lock feature.
Steps to cancel an ongoing wash programme.
What happens when a programme finishes and indicators.
Explanation of the automatic energy-saving feature.
Steps to clean the detergent dispenser drawer.
How to clean the washing drum and door seal.
How to clean the exterior surfaces and control panel.
Instructions for cleaning the water inlet filters.
Steps to drain residual water and clean the pump filter.
To Next Page
General
