Beko WMB 50821 - Water Discharge Procedures

14
EN
C
 Youcanremovethefiltercoverbyslightly
pushing downwards with a thin plastic tipped
tool,throughthegapabovethefiltercover.Do
not use metal tipped tools to remove the cover.
Some of our products have emergency draining hose
andsomedoesnothave.Followthestepsbelowto
discharge the water.
Dischargingthewaterwhentheproducthasan
emergency draining hose:
Pull the emergency draining hose out from its seat
Placealargecontainerattheendofthehose.Drain
thewaterintothecontainerbypullingouttheplugat
theendofthehose.Whenthecontainerisfull,block
theinletofthehosebyreplacingtheplug.Afterthe
containerisemptied,repeattheaboveprocedure
to drain the water in the machine completely. When
drainingofwaterisfinished,closetheendbythe
plug again and fix the hose in its place. Turn the
pump filter to take it out.
Dischargingthewaterwhentheproductdoesnot
have an emergency draining hose:
Place a large container in front of the filter to
catch water from the filter. Loosen pump filter
(anticlockwise) until water starts to flow. Fill the
flowing water into the container you have placed in
front of the filter. Always keep a piece of cloth handy
toabsorbanyspilledwater.Whenthewaterinside
the machine is finished, take out the filter completely
byturningit.Cleananyresiduesinsidethefilteras
wellasfibers,ifany,aroundthepumpimpellerregion.
Installthefilter.
A
 Ifyourproducthasawaterjetfeature,besure
to fit the filter into its housing in the pump.
Never force the filter while installing it into its
housing. Seat the filter into its place completely.
Otherwise,watermayleakfromthefiltercap.
Ifthefiltercapiscomposedoftwopieces,closethe
filtercapbypressingonthetab.Ifitisonepiece,seat
thetabsinthelowerpartintotheirplacesfirst,and
then press the upper part to close.