Why is my Beko Washer not draining water?
Your Beko washer might not be draining water because the water drain hose is clogged or twisted. Clean or flatten the hose. Alternatively, the pump filter might be clogged, so you should clean the pump filter.
Why won't my Beko WMY 81243 PTLMB1 Washer door open?
The loading door of your Beko washer might not open due to several reasons: * The door lock is activated because of the water level in the machine. Drain the water by running the Pump or Spin programme. * The machine is heating up the water or it is at the spinning cycle. Wait until the programme completes. * The child lock is engaged. Wait for a couple of minutes for deactivation of the door lock.
How to fix Beko WMY 81243 PTLMB1 that won't fill with water?
If your Beko washer isn't filling with water, check the following: * Ensure the tap is turned on. If not, turn on the taps. * Check if the water inlet hose is bent. If so, flatten the hose. * Inspect the water inlet filter for clogs. If clogged, clean the filter. * Make sure the loading door is completely closed. Close the door if it's open.
Why is my Beko WMY 81243 PTLMB1 Washer vibrating so much?
There are several reasons why your Beko washer might be vibrating or making excessive noise: * The machine might be standing unbalanced. Adjust the feet to level the machine. * A hard substance might have entered into the pump filter. Clean the pump filter. * Transportation safety bolts are not removed. Remove the transportation safety bolts. * Laundry quantity in the machine might be too little. Add more laundry to the machine. * The machine might be overloaded with laundry. Take out some of the laundry from the machine or distribute the load by hand to balance it homogenously in the machine. * The machine might be leaning on a rigid item. Make sure that the machine is not leaning on anything.
What to do if my Beko WMY 81243 PTLMB1 Washer takes longer than usual?
Several factors can cause your Beko washer to take longer than the time specified in the manual: * Low water pressure: The machine waits until it takes in enough water, extending the washing time. * Low voltage: Washing time is prolonged to avoid poor washing results. * Low input water temperature: The time to heat the water extends in cold seasons. * Increased rinses: The machine increases rinse water or adds an extra rinse if needed. * Excessive foam: Too much detergent can activate the automatic foam absorption system, prolonging the wash.
Why does my Beko Washer immediately discharge the water?
If your Beko washer immediately discharges the water it takes in, the draining hose might not be at adequate height. Connect the water draining hose as described in the operation manual.
To Next Page
General
