Why is foam overflowing from the detergent drawer of my Beko WMY 81283 SLB2?
If foam is overflowing from the detergent drawer of your Beko Washer, too much detergent is used. Mix 1 tablespoonful of softener with ½ l of water and pour into the main wash compartment of the detergent drawer.
How to open the loading door of my Beko WMY 81283 SLB2?
If the loading door of your Beko Washer won't open, it could be due to several reasons. The door lock might be activated because of the water level; drain the water by running the Pump or Spin programme. The machine might be heating up the water or at the spinning cycle; wait until the programme completes. The child lock might be engaged; wait a couple of minutes for deactivation. Also, the loading door may be stuck because of the pressure; grab the handle and push and pull the loading door to release and open it.
Why is my Beko WMY 81283 SLB2 not filling with water?
If your Beko Washer isn't filling with water, check if the tap is turned on. Also, the water inlet hose might be bent; flatten the hose. The water inlet filter might be clogged; clean the filter. Ensure that the loading door is closed.
Why is my Beko WMY 81283 SLB2 Washer leaking water from the bottom?
If water is leaking from the bottom of your Beko Washer, the water drain hose might be clogged or twisted; clean or flatten the hose. Alternatively, the pump filter might be clogged; clean the pump filter.
Why my Beko WMY 81283 SLB2 does not rinse well?
If your Beko Washer does not rinse well, the amount, brand, and storage conditions of the detergent may be inappropriate. Use a detergent suitable for washing machines and laundry, and store it properly. Ensure detergent is put in the correct compartment. Check the pump filter and drain hose for clogs or folds.
What to do if the programme cannot be started or selected on my Beko WMY 81283 SLB2 Washer?
If the programme cannot be started or selected on your Beko Washer, the machine may have switched to self-protection mode due to a supply problem (line voltage, water pressure, etc.). Press and hold the On / Off button for 3 seconds.
What to do if my Beko WMY 81283 SLB2 Washer stopped shortly after the programme started?
Your Beko Washer might have stopped temporarily due to low voltage. It will resume running when the voltage restores to the normal level.
Why does my Beko WMY 81283 SLB2 Washer directly discharge the water it takes in?
The draining hose of your Beko Washer might not be at adequate height. Connect the water draining hose as described in the operation manual.
Why is the laundry turning gray after washing in my Beko WMY 81283 SLB2?
If your laundry is turning gray after washing in your Beko Washer, you may not be using enough detergent over a long period. Use the recommended amount for your water hardness and laundry load. Washing at low temperatures for too long can also cause this. Insufficient detergent with hard water causes soil to stick to clothes, turning them gray. Using too much detergent may also cause this issue. Once graying happens, it's difficult to reverse.
Why too much foam forms in my Beko Washer?
If excessive foam is forming in your Beko Washer, it may be caused by using improper detergents, so use detergents appropriate for washing machines. Using too much detergent can also cause this issue, so use only a sufficient amount. Improper storage of detergent, such as in excessively hot places, can contribute to the problem, so store detergent in a closed, dry location. Some meshed laundry items, like tulle, may create excessive foam due to their texture; use smaller amounts of detergent for these items. Ensure the detergent is placed in the correct compartment.
Safety precautions for preventing damage to life and property during operation.
Guidelines to ensure the safe use of the washing machine by children.
Crucial safety information regarding electrical connections and potential hazards.
Warnings about hot surfaces, particularly the door glass, during operation.
Information on WEEE Directive compliance and eco-friendly disposal practices.
Details on the proper domestic use of the machine and its expected service life.
Guidelines for selecting a suitable installation location and initial preparation.
Steps to remove packaging reinforcement and transportation safety bolts.
How to properly connect the water supply hose to the machine.
Instructions for connecting the drain hose to a suitable drain point.
Steps for leveling the machine and making safe electrical connections.
Performing the first wash cycle and initial machine preparations.
Guidelines for sorting laundry and preparing items for washing to prevent damage.
Tips for efficient washing, energy saving, and correct load capacity.
Advice on achieving optimal washing results based on soiling and fabric types.
An explanation of the control panel's buttons, indicators, and displays for easy operation.
Guidance on choosing the right wash programme and understanding programme specifics.
How to modify temperature and spin speed settings for various wash cycles.
How to select and use additional washing functions like Prewash and Quick Wash.
Using the End Time function to delay the start of a wash programme.
Making changes during a cycle, pausing, and adding laundry.
How to add laundry mid-cycle and activate/deactivate child lock.
Procedures for cancelling programmes, ending cycles, and understanding standby mode.
Instructions for cleaning the detergent drawer and the main washing drum.
How to clean the machine's body, control panel, and intake filters.
Steps to clean the filters for water intake valves and hoses.
Steps for draining water and cleaning the essential pump filter for optimal function.
Solutions for issues preventing program start, water filling, or proper drainage.
Diagnosing and fixing causes of machine noise, vibration, and water leakage.
Troubleshooting why the machine stops mid-cycle or the door remains locked.
Solutions for countdown issues and the machine not reaching the spinning step.
Resolving laundry turning gray, persistent stains, or faded colors.
Resolving issues with unpleasant smells, oily stains, or fabric stiffness.
Troubleshooting poor rinsing, stiff laundry, and detergent residue in the drawer.
Fixing problems with excessive foaming, overflowing detergent, and wet clothes.
General| Load Capacity | 8 kg |
|---|---|
| Spin Speed | 1200 rpm |
| Energy Efficiency Class | A+++ |
| Number of Programs | 15 |
| Noise Level (Spinning) | 76 dB |
| Color | White |
To Next Page