Why can't I start or select a program on my Beko Washer?
If your Beko Washer program cannot be started or selected, this is likely due to a supply problem such as issues with the line voltage or water pressure. To cancel the current program, simply turn the Programme Selection knob to select another program. This will cancel the previous selection.
What to do if laundry remains wet at the end of Beko WRE 7512 XWW programme?
If your laundry remains wet after the Beko Washer program finishes, it could be because excessive foam occurred, activating the automatic foam absorption system due to too much detergent. Make sure to use the recommended amount of detergent. Another reason could be that the machine didn't switch to the spinning step because the laundry wasn't evenly distributed in the drum. In this case, rearrange the laundry and try re-spinning it.
Why is my Beko WRE 7512 XWW Washer vibrating or making noise?
If your Beko Washer vibrates excessively or makes unusual noises, several factors could be at play. The machine might be unbalanced, so adjust the feet to level it. A hard substance might be lodged in the pump filter, requiring you to clean the filter. Ensure the transportation safety bolts have been removed. Also, the laundry quantity might be too little or too much; try adding or removing some items, or distribute the load evenly by hand. Finally, check that the machine isn't leaning on any rigid object.
How to stop foam from overflowing from my Beko Washer detergent drawer?
If foam is overflowing from the detergent drawer of your Beko Washer, it's likely due to using too much detergent. To resolve this, mix 1 tablespoonful of softener with ½ liter of water and pour it into the main wash compartment of the detergent drawer. Also, ensure you are using the correct type and amount of detergent suitable for the selected program and load size, as indicated in the 'Programme and consumption table'. Reduce the amount of detergent used if you're also using additional chemicals like stain removers or bleach.
Why does the programme time not countdown on my Beko WRE 7512 XWW?
If the program time on your Beko Washer isn't counting down (on models with a display), the timer might pause during water intake. The timer indicator won't countdown until the machine takes in enough water to ensure effective washing. It will resume once sufficient water is present. The timer may also stop during the heating step until the machine reaches the selected temperature. Additionally, the automatic unbalanced load detection system might be activated if the laundry is not evenly distributed; in this case, the laundry should be rearranged and re-spun.
To Next Page
General