Beko WTB620E1W - Page 34

34 / EN
Washng Machne / User’s Manual
In order to clean the drty flter and dscharge the water:
1 Unplug the product to cut off the supply power.
A
CAUTION: Temperature of the water inside the product may rise up to 90 ºC. To avoid the
burning risk, clean the filter after the water inside the product is cooled down.
2. Open the filter cover.
3 Follow the below procedures in order to drain water.
If the product does not have an emergency water dran hose, n order to dran the
water:
a. In order to collect the water to flow out
of the filter, place a large vessel in front
of the filter.
b. Turn and loosen the pump filter until
water starts to flow (counterclockwise).
Fill the flowing water into the container
you have placed in front of the filter.
Always keep a piece of cloth handy to
absorb any spilled water.
c When the water inside the product is
finished, take out the filter completely
by turning it.
4.Clean any residues inside the filter as well as fibres, if any, around the pump impeller
region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If
it is one piece, seat the tabs in the lower part into their places first, and then press the
upper part to close.