Why does my Beko WUE6511BS laundry not smell like the softener?
A
Alexander TapiaSep 9, 2025
If your laundry doesn't smell like the softener after washing in your Beko Washer, it could be because detergent is put in the prewash compartment although the prewash cycle is not selected, so put the detergent in the correct compartment and wash and clean the dispenser with hot water. Also, the detergent might be mixed with the softener, so do not mix them and wash and clean the dispenser with hot water.
R
rhuertaAug 23, 2025
Why is there water leaking from the bottom of my Beko WUE6511BS Washer?
J
Joseph JohnsonAug 23, 2025
If you notice water leaking from the bottom of your Beko Washer, the water drain hose might be clogged or twisted, so clean or flatten it. Alternatively, the pump filter might be clogged, so clean the pump filter.
V
Veronica ArmstrongAug 25, 2025
What to do if my Beko Washer does not fill with water?
B
browntaylorAug 25, 2025
If your Beko Washer isn't filling with water, check if the tap is turned off and turn it on. Also, the water inlet hose may be bent, so flatten it. The water inlet filter could be clogged, so clean it. Finally, make sure the loading door is closed.
B
browningjacobAug 26, 2025
What to do if my Beko WUE6511BS loading door cannot be opened?
M
Michael MitchellAug 27, 2025
If the loading door of your Beko Washer won't open, it could be due to several reasons: the door lock might be activated because of the water level, so drain the water by running the Pump or Spin programme; the machine might be heating water or is at the spinning cycle, so wait until the programme completes; the child lock might be engaged, so wait a couple of minutes for it to deactivate; or the door might be stuck due to pressure, so grab the handle and push and pull the door to release it.
A
Anna BooneAug 27, 2025
What to do if my Beko Washer programme does not start after closing the door?
A
Austin Silva DDSAug 27, 2025
If the programme on your Beko Washer doesn't start after closing the door, it might be because the Start / Pause / Cancel button wasn't pressed, so press it. Also, the loading door may be difficult to close if there's too much laundry, so reduce the amount and ensure the door is closed properly.
K
Kelly MillerAug 29, 2025
What to do if my Beko WUE6511BS machine does not switch to spinning step?
R
Rachel Reyes DDSAug 29, 2025
If your Beko Washer doesn't switch to the spinning step, there might be an unbalanced load, triggering the automatic load detection system. The machine also won't spin if water isn't drained completely, so check the filter and draining hose. Excessive foam could also be the cause, so use the recommended amount of detergent.
R
Roberta NelsonSep 18, 2025
Why does my Beko WUE6511BS have too much foam?
V
Victor ChenSep 18, 2025
If too much foam forms in your Beko Washer, it could be due to using improper detergents, so use detergents appropriate for washing machines. Excessive amounts of detergent can also cause this, so use only a sufficient amount. Detergent stored under improper conditions can also lead to this issue, so store detergent in a closed and dry location, avoiding excessively hot places. Some meshed laundry like tulle may foam too much, so use smaller amounts of detergent for these items. Also, make sure you put the detergent in the correct compartment.
P
Paula AguirreSep 18, 2025
Why is my Beko Washer foam overflowing from the detergent drawer?
W
Wesley McleanSep 22, 2025
If foam is overflowing from the detergent drawer of your Beko Washer, it's likely due to using too much detergent. Mix 1 tablespoonful of softener with ½ liter of water and pour it into the main wash compartment of the detergent drawer. Also, put detergent into the machine suitable for the programmes and maximum loads indicated in the “Programme and consumption table”, and reduce the amount of detergent when using additional chemicals like stain removers or bleach.
M
Mary CunninghamSep 8, 2025
Why does my Beko Washer programme time not countdown?
K
kelly74Sep 8, 2025
If the programme time on your Beko Washer isn't counting down, the timer may stop during water intake until the machine takes in enough water. It may also stop during the heating step until the machine reaches the selected temperature. Additionally, the timer may stop during the spinning step due to the automatic unbalanced load detection system.
S
Sarah WilsonSep 4, 2025
Why does my Beko WUE6511BS Washer vibrate or make noise?
L
Larry LewisSep 4, 2025
Your Beko Washer might be vibrating or making noise due to several reasons: it might be unbalanced, so adjust the feet to level it; a hard substance might be in the pump filter, requiring you to clean it; the transportation safety bolts might not be removed, so remove them; the laundry quantity might be too little, so add more; the machine might be overloaded, so take some laundry out; or the machine might be leaning on something, so ensure it's not.
To Next Page
General
Weight and Dimensions
