Beko WUE6511XWW - User Manual

Questions and Answers

J
Jeremy AustinSep 23, 2025
Why is there detergent residue in the detergent drawer of my Beko Washer?
- R
  Rachel JenkinsSep 23, 2025
  If you see detergent residue in the detergent drawer of your Beko Washer, the detergent is put in wet drawer, so dry the detergent drawer before putting in detergent. The detergent has gotten damp, so keep detergents closed in an environment free of humidity and do not expose them to excessive temperatures. The water pressure is low, so check the water pressure. The detergent in the main wash compartment got wet while taking in the prewash water, so check the holes and clean if they are clogged. There is a problem with the detergent drawer valves. Detergent might be mixed with the softener, so do not mix the softener with detergent and wash and clean the dispenser with hot water. Regular drum cleaning is not applied, so clean the drum regularly.
W
William CortezAug 23, 2025
How to open the loading door of Beko WUE6511XWW Washer?
- O
  Olivia PenaAug 25, 2025
  If the loading door of your Beko Washer cannot be opened, it may be due to the door lock being activated because of the water level in the machine. Drain the water by running the Pump or Spin programme. The machine may be heating up the water or it is at the spinning cycle, so wait until the programme completes. If the child lock is engaged, wait a couple of minutes for deactivation of the door lock. The loading door may be stuck because of the pressure it is subjected to, so grab the handle and push and pull the loading door to release and open it.
R
Randy ChristianAug 25, 2025
Why is my Beko Washer leaking from the bottom?
- J
  John HendersonAug 26, 2025
  If your Beko Washer is leaking water from the bottom, the water drain hose might be clogged or twisted, so clean or flatten the hose. Also, the pump filter could be clogged, so clean the pump filter.
M
Mackenzie AndrewsAug 27, 2025
Why is my Beko Washer not filling with water?
- C
  Christopher HuberAug 27, 2025
  If your Beko Washer isn't filling with water, first, turn on the taps. If the water inlet hose is bent, flatten it. If the water inlet filter is clogged, clean the filter. Lastly, ensure the loading door is closed.
L
Latasha RochaAug 27, 2025
Why Beko Washer does not rinse well?
- R
  Ronald LoveAug 27, 2025
  If it does not rinse well after washing with your Beko Washer, the amount, brand and storage conditions of the detergent used are inappropriate, so use a detergent appropriate for the washing machine and your laundry and keep detergents closed in an environment free of humidity and do not expose them to excessive temperatures. Detergent is put in the wrong compartment, so if detergent is put in the prewash compartment although prewash cycle is not selected, machine can take this detergent during rinsing or softener step, so put the detergent in the correct compartment. The pump filter is clogged, so check the filter. The drain hose is folded, so check the drain hose.
S
Sean GarrettSep 16, 2025
Why does laundry not smell like the softener after washing in my Beko Washer?
- J
  Jason MooreSep 16, 2025
  If your laundry does not smell like the softener after washing in your Beko Washer, detergent is put in the wrong compartment, so if detergent is put in the prewash compartment although prewash cycle is not selected, machine can take this detergent during rinsing or softener step. Wash and clean the dispenser with hot water and put the detergent in the correct compartment. Detergent might be mixed with the softener, so do not mix the softener with detergent. Wash and clean the dispenser with hot water.
B
Bianca GlennSep 13, 2025
Why does laundry became stiff after washing in my Beko WUE6511XWW Washer?
- L
  Louis WilliamsSep 13, 2025
  If your laundry became stiff after washing in your Beko Washer, insufficient amount of detergent is used, so using insufficient amount of detergent for the water hardness can cause the laundry to become stiff in time, so use appropriate amount of detergent according to the water hardness. Detergent is put in the wrong compartment, so if detergent is put in the prewash compartment although prewash cycle is not selected, machine can take this detergent during rinsing or softener step, so put the detergent in the correct compartment. Detergent might be mixed with the softener, so do not mix the softener with detergent. Wash and clean the dispenser with hot water.
V
virginiastoutSep 14, 2025
Why is foam overflowing from the detergent drawer of my Beko WUE6511XWW Washer?
- J
  james05Sep 15, 2025
  If foam is overflowing from the detergent drawer of your Beko Washer, it could be because too much detergent is used, so mix 1 tablespoonful softener and ½ l water and pour into the main wash compartment of the detergent drawer. Detergent might be mixed with the softener, so put detergent into the machine suitable for the programmes and maximum loads indicated in the "Programme and consumption table". When you use additional chemicals (stain removers, bleachs and etc), reduce the amount of detergent.
D
Derek FlynnSep 5, 2025
Why did my Beko WUE6511XWW stop shortly after the programme started?
- R
  Rose WaltersSep 5, 2025
  If your Beko Washer stopped shortly after the programme started, the machine might have stopped temporarily due to low voltage. It will resume running when the voltage restores to the normal level.
M
Mr. Robert RiceSep 3, 2025
Why does washing take longer time than specified in the manual with my Beko WUE6511XWW?
- F
  Faith HawkinsSep 3, 2025
  If the washing cycle on your Beko Washer is taking longer than specified, it could be due to low water pressure. The machine waits until taking in adequate amount of water to prevent poor washing quality due to the decreased amount of water. Voltage might be low, so washing time is prolonged to avoid poor washing results. The input temperature of water might be low, so required time to heat up the water extends. The number of rinses and/or amount of rinse water might have increased, because machine increases the amount of rinse water when good rinsing is needed. Excessive foam might have occurred and automatic foam absorption system might have been activated due to too much detergent usage, so use recommended amount of detergent.

Summary

General Safety Instructions

Life and Property Safety

Safety instructions to prevent injuries and material damage related to product usage.

Childrens Safety

Guidelines for safe use by children and precautions for child safety.

Electrical and Environmental Safety

Electrical Safety

Precautions regarding electrical connections, grounding, and handling of the power cable.

Installation Guide

Installation Location Requirements

Removing Transportation Locks

Instructions on how to remove transportation safety bolts before operating the machine.

Water and Electrical Connections

Water Supply Connection

Detailed steps for connecting the water supply hose and relevant precautions.

Drain Hose Connection

Instructions for correctly connecting the drain hose to a waste outlet at the specified height.

Installation Adjustments and Initial Use

Adjusting Machine Feet

Electrical Connection Safety

Guidelines for safely connecting the washing machine to the electrical supply, including grounding.

Detergent and Additive Usage

Using Detergent and Softener

Detailed instructions on how to use detergent, softener, and other cleaning agents correctly.

Specific Detergent Types and Agents

Using Liquid, Gel, and Tablet Detergents

Specific instructions for using different types of detergents and cleaning agents.

Operating the Washing Machine

Control Panel Overview

Explanation of the washing machine's control panel, buttons, and indicators.

Programme Selection and Efficiency Tips

Program Details and Consumption

Programme and Consumption Table

Table detailing wash programs, load capacities, durations, and consumption figures.

Program Descriptions

Main and Additional Wash Programs

Advanced Operation Features

Delayed Start and Program Timing

Instructions on how to set a delayed start and manage program timing.

Child Lock Feature

Maintenance and Cleaning Procedures

Detergent Drawer Cleaning

Drum and Loading Door Cleaning

Water Intake Filter Cleaning

Advanced Maintenance

Draining Water and Pump Filter Cleaning

How to drain remaining water from the machine and clean the pump filter.

Troubleshooting Common Issues

Program Start and Selection Issues

Solutions for problems preventing the program from starting or being selected.

Water Filling and Draining Problems

Vibration, Noise, and Leaks

Program Interruption and Door Issues

Extended Washing Times and Water Visibility

Rinsing and Detergent Issues

Rinse Quality and Detergent Residue

Foam Overflow and Laundry Wetness

Foam Overflow and Wet Laundry

Beko WUE6511XWW Specifications

General

Door type	Tempered glass
Drum type	Aquawave
Door hinge	Left
Control type	Buttons, Rotary, Touch
Display type	LED
Door opening	Side opening
Loading type	Front-load
Product color	White
Built-in display	Yes
Door opening angle	170 °
Appliance placement	Freestanding
Self-cleaning	-
Current	10 A
Connected load	1550 W
AC input voltage	230 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Power consumption (off)	0.5 W
Power consumption (standby)	1 W
Water consumption per cycle	43 L
Energy consumption washing per cycle	0.73 kWh
Drum capacity	6 kg
Menu languages	English
Cycle time (max)	197 min
Delay start (max)	9 h
Residual moisture	62 %
Spin-drying class	C
Maximum spin speed	1000 RPM
Minimum spin speed	400 RPM
Noise level (spin)	72 dB
Noise level (wash)	60 dB
Number of washing programs	15
Maximum washing temperature	90 °C