EasyManua.ls Logo

Beko WUE7511XWW - User Manual

Beko WUE7511XWW
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1911861257_EN / 30-03-20.(16:24)
Document Number=
WUE7511XWW
EN/HR/SL
Washing Machine
User’s Manual
Perilica rublja
Korisnički priručnik
Pralni stroj
Uporabniški priročnik

Table of Contents

Questions and Answers

  • J
    Javier MartinSep 23, 2025
    Why is foam overflowing from the detergent drawer of my Beko WUE7511XWW Washer?
    • J
      James HouseSep 23, 2025
      If foam is overflowing from the detergent drawer of your Beko Washer, it's likely that too much detergent is being used, so mix 1 tablespoonful of softener with ½ l of water and pour it into the main wash compartment. Also, ensure you are using the correct amount of detergent suitable for the programmes and maximum loads. Reduce the amount of detergent when using additional chemicals like stain removers or bleach.
  • B
    beverly36Aug 23, 2025
    What to do if the Beko WUE7511XWW Washer loading door cannot be opened?
    • J
      Jennifer BruceAug 23, 2025
      If the loading door of your Beko Washer cannot be opened, it could be due to several reasons: the door lock is activated because of the water level, so drain the water by running the Pump or Spin programme. The machine might be heating water or at the spinning cycle, so wait until the programme completes. The child lock might be engaged, so wait a couple of minutes for deactivation. The door may be stuck due to pressure, so grab the handle and push and pull the door to release it.
  • W
    wyattelizabethAug 25, 2025
    Why does my Beko WUE7511XWW Washer not switch to the spinning step?
    • C
      Catherine CookAug 26, 2025
      Your Beko Washer might not switch to the spinning step if there's an unbalanced load, in which case the automatic unbalanced load detection system might be activated. Also, the machine won't spin if the water isn't drained completely, so check the filter and the draining hose. Excessive foam might also prevent spinning, so use the recommended amount of detergent.
  • J
    Jennifer McdanielAug 27, 2025
    What to do if my Beko WUE7511XWW machine does not fill with water?
    • T
      Timothy NelsonAug 27, 2025
      If your Beko Washer isn't filling with water, first, make sure the tap is turned on. Check if the water inlet hose is bent and flatten it if it is. Also, the water inlet filter might be clogged, so clean the filter. Finally, make sure the loading door is closed.
  • M
    murphyalexandraAug 27, 2025
    Why does my Beko WUE7511XWW programme not start after closing the door?
    • E
      Erin WilsonAug 28, 2025
      If the programme on your Beko Washer doesn't start after closing the door, ensure that you have pressed the Start / Pause / Cancel button. Also, if you have loaded too much laundry, it may be difficult to close the loading door, so reduce the amount of laundry and make sure the loading door is closed properly.
  • T
    thomassolisSep 18, 2025
    Why is there too much foam in my Beko WUE7511XWW?
    • J
      Jason CamposSep 18, 2025
      Too much foam in your Beko Washer might be due to using improper detergents, so use detergents appropriate for washing machines. You might be using an excessive amount of detergent, so use only a sufficient amount. Improper storage of detergent can also cause this, so store detergent in a closed, dry location. Some meshed laundry may foam too much, so use smaller amounts of detergent for these items. Ensure detergent is put in the correct compartment.
  • L
    laura85Sep 15, 2025
    Why does my Beko Washer directly discharges the water it takes in?
    • S
      Scott ContrerasSep 15, 2025
      Your Beko Washer might be directly discharging the water it takes in because the draining hose might not be at adequate height. Connect the water draining hose as described in the operation manual.
  • J
    Jon SparksSep 16, 2025
    Why does my Beko Washer programme cannot be started or selected?
    • J
      Jasmin SmithSep 16, 2025
      The washing machine may have switched to self-protection mode due to a supply problem (line voltage, water pressure, etc.). Press and hold the On / Off button for 3 seconds.
  • M
    Michael MooreSep 6, 2025
    Why is there detergent residue in the detergent drawer of my Beko Washer?
    • H
      haleyjamesSep 7, 2025
      Detergent residue in the detergent drawer of your Beko Washer can occur if the detergent is put in a wet drawer, so dry the drawer before adding detergent. Detergent may have gotten damp, so keep detergents closed in a dry environment. Low water pressure can also cause this, so check the water pressure. If the holes of the detergent compartment are blocked, clean them. Avoid mixing softener with detergent and clean the dispenser. The drum may need regular cleaning.
  • B
    Brian GarrettSep 4, 2025
    Why does my Beko WUE7511XWW Washer laundry not smell like the softener?
    • E
      ewheelerSep 4, 2025
      If your laundry doesn't smell like softener after washing in your Beko Washer, it might be because detergent is put in the prewash compartment when prewash isn't selected, so put the detergent in the correct compartment and wash the dispenser with hot water. Also, avoid mixing the softener with detergent; clean the dispenser with hot water.

Summary

General Safety Instructions

Life, Property, and Childrens Safety

Safety guidelines for users, property, and children.

Electrical and Hot Surface Safety

Critical safety precautions regarding electrical hazards and hot surfaces.

Environmental and Usage Guidelines

Environmental Compliance and Disposal

Information on WEEE and RoHS directives, and proper product disposal.

Intended Use and Product Lifespan

Defines the product's intended domestic use and its expected service life.

Technical Specifications

Installation Guide

Installation Location and Preparation

Guidance on selecting an installation site and preparing the machine, including removing packaging.

Removing Transportation Locks

Essential steps for removing transportation safety bolts before operation.

Connecting Water and Drain Hoses

Instructions for correctly connecting water supply and drain hoses.

Final Installation Adjustments and Electrical Connection

Steps for adjusting feet, making electrical connections, and initial machine setup.

Wash Cycle Preparation

Laundry Preparation and Sorting

Advice on sorting laundry and preparing items for washing.

Loading and Load Capacity

Guidance on how to load laundry and the correct load capacity.

Using Detergents and Softeners

Detailed instructions on selecting and using laundry care products.

Efficient Washing Tips

Recommendations for saving energy and water during washes.

Program Timing Explanation

Explanation of how program duration is displayed and adjusted.

Operating the Product

Control Panel Overview

Explanation of the control panel, buttons, and indicator lights.

Machine Preparation and Programme Selection

Steps to prepare the machine and select appropriate wash programmes.

Programme and Consumption Data

Table showing programme details, load capacities, and resource consumption.

Understanding Wash Programmes

Descriptions of the primary and additional wash programmes available.

Special Programmes and Speed Settings

Information on additional programmes, special functions, and adjusting spin speed.

Advanced Operation Features

Using delayed start, child lock, and starting programmes.

Programme Progress and Cycle Management

Monitoring progress, door lock, changing settings mid-cycle, and cancelling programmes.

Programme End and Pause Mode

Procedures for programme completion and the machine's pause mode functionality.

Maintenance and Cleaning

Detergent Drawer and Drum Cleaning

Instructions for cleaning the detergent drawer and the washing drum.

Body, Panel, and Filter Cleaning

Guidance on cleaning the exterior, control panel, and water intake filters.

Draining Water and Pump Filter Maintenance

How to drain water and clean the pump filter for maintenance or transport.

Troubleshooting

Beko WUE7511XWW Specifications

General IconGeneral
TypeFront Load
Capacity7 kg
Spin Speed1200 rpm
Energy Efficiency ClassA+++
Dimensions (H x W x D)84 cm x 60 cm x 49 cm
Weight70 kg
Noise Level Spinning75 dB
Programs15

Related product manuals