Belcat UK-300T User Manual

: Tuning Guide LED for Sharp tune
: Tuning Guide LED for right tune
: Tuning Guide LED for flat tune
2Band EQ with Chromatic LED tuner
1. Tuner LED Display
2. Bass
3. Treble
4. Volume Knob
5. Low Batt. (Low Battery LED Light)
6. Tuner on/off Button
7. Battery box
Tuner LED Display
The BASS, TREBLE controls are a 3-band equalizer for controlling
tone.
The center detent on these tone controls yields a flat tone response.
“+12" boosts the tone; “12"cuts the tone.
The LED will light when the battery has lost power. Replace the
battery when this light is on.
This LED light will flash when a cable is connected to the output
jack of the pickup system. This shows the battery is good.
The VOLUME controls the output volume. At “0" it is completely OFF.
At “10" it is loud.
Caution
- The jack should be pluged for proper Preamp working.
(TUNER will works regardless pluging jack)
- There is no output sound, please check if tuner or mute is turned on.
- When LCD screen is dim or no display, please check battery life.
- To prevent battery loss, please unplug jack when preamp is not in use.
- Do not disassemble for repair.
Return to your dealer for service or repair.
- Do not use too much force when operating the control.
Specification
3 4
1
2
1. Tuner LED Display
2. Bass (for bass tones)
3. Treble (for high tones)
4. Volume Knob
5. Low Batt. (Low Battery LED Light)
6. Tuner on/off Button
7. Battery box
Functions
UK-300T USER’S MANUAL
Features : 2Band EQ with Chromatic LED tuner
Input Impedance : 22 MΩ
Frequency Response : 20Hz ~ 20KHz
Control Range
Bass : +/-12dB at 100Hz
Treble : +/-12dB at 10KHz
Battery Status LED
Power Supply : 2 X CR2032 Coin Battery
Battery Life
Only Eq : Over 200Hours
Tuner on : Over 100Hours
Pick-up : Omega II Piezo Cable pick-up
Dimension : W 56mm X H 40mm (2.2" X 1.6")
1
2
3
4
5
6
7
Power switch of built-in Chromatic LED tuner.
Automatic power off after 5 minutes
2 X CR2032 Coin Battery

Belcat UK-300T Specifications

General

Brand	Belcat
Model	UK-300T
Category	Amplifier
Language	English

Summary

Functions

Tuner LED Display

Displays tuning status, including sharp, right, and flat indicators.

Bass and Treble Controls

3-band equalizer for controlling tone, with center detent for flat response.

Volume Knob

Adjusts the overall output volume, with 0 being completely OFF.

Low Battery LED Light

Indicates low battery status and flashes when a cable is connected.

Tuner On/Off Button

Powers the built-in chromatic LED tuner on/off with automatic power off.

Battery Box

Houses the 2 x CR2032 coin batteries for power.

Specification

Features and Technical Specifications

Details features like 2-band EQ, tuner, input impedance, and frequency response.

Control Range

Specifies the adjustment range for Bass (+/-12dB at 100Hz) and Treble (+/-12dB at 10KHz).

Battery Specifications

Covers power supply type and estimated battery life for different modes.

Pick-up and Dimensions

Identifies the pick-up type and provides the physical dimensions of the unit.

Caution and Troubleshooting

Preamp and Sound Issues

Notes on preamp operation, no sound troubleshooting, and battery life checks.

Usage and Maintenance Advice

Recommendations to prevent battery loss, avoid disassembly, and use controls gently.

Installation Manual

Contents and Tools Required

Lists the components included and the necessary tools for installation.

Installation Steps

Step-by-step guide for cutting, drilling, inserting components, and connecting the pick-up.

Installation Solutions

Troubleshooting common issues like no sound, hum-noise, and balance problems.

Cutting Template

Template Instructions

Instructions for printing, scaling, and using the template for preamp opening.

Preamp Opening Dimensions

Provides precise measurements for the preamp opening on the guitar.