What to do if Status LED is steady red on Belden Grass Valley Kaleido-Modular-X Monitor?
If the Status LED on your Belden Monitor is steadily red (not flashing), it indicates that the firmware initialization or update is in progress. To resolve this, do not interrupt the process.
How to fix a flashing red Status LED on Belden Grass Valley Kaleido-Modular-X?
If the Status LED on your Belden Monitor is flashing red, it indicates a fan failure or no rear. Check the fan or the rear of the device to solve this problem.
Why is the SDI LED red on my Belden Monitor?
If the SDI LED on your Belden Monitor is red, this indicates that no input signal has been detected. To resolve this, verify the input signal.
What does it mean when the REF LED is red on a Belden Grass Valley Kaleido-Modular-X Monitor?
If the REF LED is red on your Belden Monitor, it means no signal has been detected. You should verify the REF input signal.
What should I do if the ABT LED is red on my Belden Monitor?
If the ABT LED on your Belden Monitor is red, this indicates that no signal has been detected. To resolve this, verify the ABT/MADI signal.
How to troubleshoot a Belden Monitor with Power LED OFF?
If the Power LED is OFF on your Belden Monitor, it suggests a failure of the 1.8V or 3.3V on-board PSUs. Check the power supplies to resolve this issue.
General| Humidity | 10% to 90% non-condensing |
|---|---|
| Type | Multiviewer |
| Display Type | Modular |
| Screen Size | Various (Modular) |
| Video Inputs | SDI, HDMI |
| Video Outputs | SDI, HDMI |
| Supported Formats | SD, HD, 3G-SDI, UHD |
| Audio Inputs | Embedded Audio |
| Audio Outputs | Embedded Audio |
| Control Interfaces | Ethernet |
| Power Supply | 100-240V AC, 50/60Hz |
| Dimensions | Varies with configuration |
| Form Factor | Modular |
| Input Interfaces | SDI, HDMI |
| Mounting Options | Rack-mountable |
| Operating Temperature | 0 to 40°C |
| Storage Temperature | -20 to 60°C |
To Next Page
