Installation BRS20/22/30/32/40/42/50/52
Release
12
01/2022
59
3 Making basic settings
Note: 2 or more devices configured with the same IP address can cause
unpredictable operation of your network.
Install and maintain a process that assigns a unique IP address to every
device in the network.
The IP parameters must be entered when the device is installed for the first
time. The device provides the following options for configuring IP addresses:
Input via the HiView or Industrial HiVision application. You find further
information about the applications HiView or Industrial HiVision on the
Internet at the Hirschmann product pages:
HiView
http://www.hirschmann.com/en/QR/INET-HiView
Industrial HiVision
http://www.hirschmann.com/en/QR/INET-Industrial-HiVision
Configuration via BOOTP
Configuration via DHCP (Option 82)
AutoConfiguration AdapterACA22-USB-C (EEC)
Configuration via USB-C interface
Default settings
IP address: The device looks for the IP address using DHCP
Ethernet ports: link status is not evaluated (signal contact)
Optical ports: Full duplex
TP ports: Autonegotiation
RSTP (Rapid Spanning Tree) activated
3.1 First login (Password change)
To help prevent undesired access to the device, it is imperative that you
change the default password during initial setup.
Perform the following steps:
Open the Graphical User Interface, the Command Line Interface, or
HiView the first time you log on to the device.
Log on to the device with the default password “private”. The device
prompts you to type in a new password.
Type in your new password.
To help increase security, choose a password that contains at least 8
characters which includes upper-case characters, lower-case characters,
numerical digits, and special characters.
To Next Page
Loading...
