Need help?Do you have a question about the Belden Hirschmann RED25 Series and is the answer not in the manual?
Overview of RED25 device variants and configurable criteria.
Explains device name correspondence to product code and characteristics.
Illustrates front/rear views of RED25 with labeled components.
Details power supply connection via a 6-pin terminal block.
Describes 10/100 Mbit/s twisted pair and 100 Mbit/s F/O ports.
Explains LEDs indicating device and port status.
Covers V.24 and USB interfaces for device management.
Describes the relay contact for remote diagnosis and control.
Steps to verify package contents and check for damage.
Procedures for mounting on DIN rail and grounding.
Instructions for installing optional SFP modules.
Guidelines for safely connecting power and signal lines.
Instructions on powering and operating the device.
Recommendations for data cable connections in high-interference environments.
Guidance on using the inscription label for identification.
Step-by-step guide to detach the device from mounting.
Procedure for removing an installed SFP transceiver.
Essential safety precautions for operating the device safely.
Defines necessary qualifications for personnel working on the device.
Specifies correct applications and conditions for product use.
States compliance with EU directives like RoHS and EMC.
Device compliance with FCC rules for interference, subject to conditions.
Guidance on proper disposal of the device as electronic waste.
Explains the meaning of symbols used in the manual for structure and navigation.
To Next Page
General
