BELIMED WD230 - Page 3

Technical Manual WD 230 and WD 250
Rev. 1.8 PF Page 3 73018_E rev 1 8-Technical Manual.doc
4.6.2 Maintenance Warning........................................................................................29
4.6.3 Naming Automat ................................................................................................29
4.6.4 Input Door Pressure...........................................................................................29
4.6.5 Suppressing liquid drainage acc. ∫ 18 ISSG Infection protection law (BGA / RKI)30
4.6.6 Automatic Program Recognition ........................................................................31
4.6.7 Display and Message in case of error. ..............................................................31
4.6.8 At Program end, CS door opens automatic .......................................................32
4.6.9 Door Interlock Unclean Side: .............................................................................32
4.6.10 User Identification ..............................................................................................32
4.6.11 Automatic Rack Identification ............................................................................33
4.6.12 Input batch content on or off ..............................................................................33
5. Printouts .........................................................................................................................34
6. Hardware Configuration................................................................................................35
6.1 Outputs.......................................................................................................................35
6.2 Inputs .........................................................................................................................36
6.2.1 SA Load cut-off (external)................................................................................37
6.2.2 SB Leakage Floor Pan.....................................................................................37
6.2.3 SC DI Boiler Code ...........................................................................................37
6.2.4 SD Float Switch DI Boiler ................................................................................37
6.2.5 SE Door US open ............................................................................................37
6.2.6 SF Door CS close ............................................................................................37
6.3 Temperature Sensor ..................................................................................................38
6.4 Interfaces ...................................................................................................................38
6.4.1 Bach documentation system Sauter ICS 8535 / 8565 .......................................38
6.4.2 Telegram assignment to Bach documentation system Sauter...........................39
6.4.3 Overview for Interface as Modem, Printer and Scanner ....................................40
7. Loading of new SW in Control Unit..............................................................................41
8. Errors with Process Interrupt and their Remedy........................................................43
8.1 Procedure in case of malfunction...............................................................................43
8.2 Color Code of Low Voltage Circuits ...........................................................................43
8.3 Error code / Error chart / Remedy ..............................................................................44
9. Cycle value and process variables of Factory Settings.............................................53
9.1 Process Time .............................................................................................................53
9.2 Water consumption and Electrical Energy .................................................................53
9.3 Validated Process Parameters P1 – P7.....................................................................53
9.4 Assignment of respective media ................................................................................53
9.5 Overview Factory Settings ........................................................................................54
9.6 P1 Alkaline Cleaning of Instruments .........................................................................56
9.7 P2 Alkaline intensive Cleaning of Instruments ...........................................................57
9.8 P3 Alkaline Cleaning of anesthetic Material...............................................................58
9.9 P4 Neutral Cleaning of Containers.............................................................................59
9.10 P5 Alkaline Cleaning of MIC Instruments...................................................................60