Belimo SY4 Series - Interface Wiring Detail SYX-MFT, 24 V, 120;230 V; Installation Notes; Caution and Safety Warnings; Operational Notes

2
Interface Wiring Detail
SYx-MFT, 24V, 120/230V
INSTALLATION NOTES
WARNING
CAUTION
APPLICATION NOTES
INSTALLATION NOTES
WARNING
WARNING
CAUTION
APPLICATION NOTES
INSTALLATION NOTES
WARNING
CAUTION
APPLICATION NOTES
INSTALLATION NOTE
S
WARNING
WARNING
CAUTION
APPLICATION NOTES
Notes:
1. Motor CAMS have been factory calibrated and should not be moved.
2. An adaption must be performed if any limit switch is adjusted. This will calibrate
the beginning and end stopping points. Press the adaption button for 3 seconds and
release.
Actuators: SYx-MFT
Control Signal +
Control Signal -
FDBK +
FDBK -
Adaption
Direction of Rotation
PC Tool Service Jack Connection
24V
Power Supply Com -
Power Supply Hot +
Control Signal +
Control Signal -
FDBK +
FDBK -
Adaption
Direction of Rotation
N
H
120/230V
PC Tool Service Jack
- Power Supply Common
- Power Supply Hot
71906-00001 Subject to change. © Belimo Aircontrols (USA), Inc.