BELINEA 10 - OSD Menu Functions; Brightness and Contrast Control; Image Control Settings; RGB Color and Other Settings

Belinea 10 20 30W - Operating Instructions - 7
ENGLISH
OSD MENU FUNCTIONS
BRIGHTNESS / CONTRAST
Brightness: Adjusts brightness by using the
buttons
< or > (
c
and
d
in fi g. 4).
Contrast: Adjusts screen contrast by using the
buttons
< or > (
c
and
d
in fi g. 4).
IMAGE CONTROL
Auto Adjustment: Automatically selects the
optimal settings for image parameters (image
position, phase, etc.) by using the button MENU
(
g
in fi g. 4).
H. Position: Controls the picture’s horizontal
position.
V. Position: Controls the picture’s vertical posi-
tion.
Clock: Sets up the internal clock. Larger values
make the displayed image appear wider; smaller
values make it appear compressed.
Phase: Adjusts the internal clock’s time lag in
order to optimize the screen image.
Sharpness: Controls image sharpness (only for
resolutions less than 1680 × 1050 pixels).
OTHER
Language: OSD menu language selection:
English, French, German, Italian, Spanish, Dutch,
Russian, Polish.
Speaker Volume: Adjusts the monitor loud-
speaker output volume.
Information: There is an optional OSD window
(on/off) that displays the newly adjusted screen
resolution settings.
Auto Switch: This option allows you to decide if
the Auto Adjustment function should take effect
after each change to the monitor’s resolution.
OSD CONTROL
H. OSD Position: Controls the OSD menu’s
horizontal position.
V. OSD Position: Controls the OSD menu’s
vertical position.
OSD Timeout: Determines how long (in seconds)
the OSD menu waits before closing automatically
after no action has been performed.
COLOR
This menu lets you select a preset color tem-
perature (9300 K, 6500 K or sRGB (D65)) by
pressing the OSD buttons
< or > (
c
and
d
in
fi g. 4). Changes to the color temperature take
immediate effect on screen. If you wish to set
individual color values, select the Custom Color
option. Then press the MENU button (
g
in fi g.
4) to select the red, green and blue settings and
set the desired value using the OSD buttons
< or > (
c
and
d
in fi g. 4). The current settings
are automatically saved when you return to the
previous level or exit the OSD menu.