Regulato
ry
and Sustalnablllty Information
NORTH
AMERICA
Safety
Instructions
WARNING: Failure to follow these ins1ruct1ons could
result
in
fire, electric shock, injury,
or
damage
to
the
user, product,
or
other
property.
1. Connect
the
power
supply
of
the wireless charger
into
a
power
outlet
that
is close
by
and
is
easy
to
disconnect
from
the
source
2.
Use
indoors
and in a
dry
location only; Avoid charging near sources
of
heat and humidity.
3.
Keep t he wireless charger and
power
supply
away
from
any
liquids
or
moisture.
4.
Unplug
the
wireless charger
when
not
in use
for
long
periods
of
time.
5.
Do
not
store
your
device in
very
hot
or
very
cold locations.
It
is
recommended
to
use
your
device
at
room
temperature
.
6.
Do
not
use
if
visible
defects
are
observed
on
the wireless charger
or
power supply.
7.
Do
not
attempt
to
service, modify,
or
disassemble
the
wireless charger
or
power
supply
.
8.
Use
of
a power
supply
not
recommended
or
sold
by
Belkin may
result
1n
an increased risk
of
fire, electric shock, injury,
or
damage
to
the
user,
product,
or
other
property.
9.
Wireless charging power transmission rate is regulated
by
the
wireless charging device receiving
power
which can
be
influenced
by
factors like,
but
not
limited
to,
proprietary
charging protocols, ambient temperature, current
battery
percentage level
and
age
of
the
device
being
charged.
CAUTION
:
If
you
experience problems
with
the
wireless charger, please discontinue use,
unplug
the
po
w
er
supply
from
the
AC
socket, and
contact
Belkin
for
assistance.
The
marking
information
is locat ed
on
the
bottom
of
the apparatus.
FCC
Statement
DECLARATION OF CONFORMITY WITH
FCC
RULES
FOR
ELECTROMAGNETIC COMPATIBILITY
We,
Belkin International,
Inc.,
of
12045
E.
Waterfront Drive, Playa Vista, CA
90094,
Tel: +1(310)
751
5100, declare under
our
sole responsibility that
this product compiles
with
Part 15
of
the
FCC
Rules.
Operation is subject
to
the following
two
conditions: (1) this device may not cause harmful
interference, and (2) this device
must
accept any interference received, including interference that may cause undesired operation.
Federal Communications Commission Interference Statement
This equipment has been tested and found
to
comply
with
the limits
for
a Class B digital device, pursuant
to
Part 15
of
the
FCC
Ru
l
es.
These limits
are designed to provide reasonable protection against harmful interference m a residential installation.
This equipment generates, uses, and can radiate radio frequency energy. and if not installed and used in accordance with the instructions. may
cause harmful interference
to
radio communications. However, there is no guarantee t
hat
interference will
not
occur in a particular installation.
If
this equipment does cause harmful interference
to
radio
or
television reception, which can be determined
by
turning the equipment
off
and on, the
user
is
encouraged
to
try
and correct the interference
by
one or more
of
the following measures:
• Reorient
or
relocate the receiving antenna.
• Increase the distance between t he equipment and the receiver.
• Connect the equipment
to
an outlet
on
a circuit different from
that
to
which the receiver
is
connected.
• Consult the dealer
or
an experienced radio/TV technician
for
help.
FCC
Caution:
Any
changes
or
modifications
not
expressly approved
by
the
party
responsible
for
compliance could void the user's
authority
to
operate this equipment.
Radiation Exposure Statement:
This equipment complies with
FCC
radiation exposure limits set forth for an uncontrolled environment. This equipment should
be
installed and operated
with a minimum distance of
20
cm
between the radiator and your body.
Innovation, Science, and Economic Development Canada Statement (ISED):
This device contains licence-exempt transmitter(s)/receiver(s)
that
comply
with
Innovation,
Sc
ience and Economic Development Canada's licence-
To Next Page
Loading...
