Belkin F5D7231 User Manual

Set-up Script
F1UP0001 and F5D7231 PRINT SERVER set up
An alternative to using the Belkin software which seems to be problematic the Print
server on the new router and the wireless print server can be set up manually using
TCP/IP.
The only setting that needs to be known before running through the following set-up
is the IP address of the print server. In the case of the F5D7231 it will be the normal
192.168.2.1 but obviously in the case of the F1UP0001 you will need to look in the
DHCP client list of the router.
1. Open the printer properties and click on Add Port, select TCP/IP
port.
©Belkin Components Ltd

Belkin F5D7231 Specifications

General

Brand	Belkin
Model	F5D7231
Category	Print Server
Language	English

Summary

F1UP0001 and F5D7231 Print Server TCP/IP Setup

Initiate TCP/IP Port Addition

Open printer properties and select 'Add Port', then choose 'TCP/IP Port'.

Welcome and Configure IP Address in Wizard

Start the TCP/IP port wizard and enter the print server's IP address.

Select Network Card and Adjust Port Settings

Choose 'Generic Network card' and configure custom settings for port numbers if needed.

Complete Standard TCP/IP Printer Port Wizard

Review and finalize the port configuration, including protocol and IP address.