Belkin Network USB Hub - Configure Automatic Device Connection

8
9
Using the Network USB Hub Control Center
1
2
3
4
5
When the other user clicks “Yes”, the device will be
disconnected automatically from that user’s computer and it
will be available for you to use.
Changing the connection settings
You can set the Control Center to automatically connect to
devices when the software launches. Selecting “Automatically
Connect” simplifies the overall experience for most users;
however, it may not be a suitable default setting if the devices
are shared among many users.
To change the connection setting, Ctrl+Click on the device
name in the list and click “Properties”; or select the device
from the list and click “Properties” on the bottom.