4 5
Using the Network USB Hub Control Center
1
2
3
4
5
Once the setup is completed, launch the Belkin Network
USB Hub Control Center through the “Start” menu. The main
Control Center (see image below) gives you a visual depiction
of your connection configuration.
You can connect to a device by Ctrl+Clicking the device on the
list, or by selecting it on the list, and then clicking “Connect”,
on the bottom of the screen. To disconnect a device, just
Ctrl+Click it on the list, or select it and then click “Disconnect”,
on the bottom of the screen.
You can change device names, settings, and more by selecting
the device from the list, and then clicking “Properties”.
To Next Page
Loading...
Need help?
General
