MOUNTING THE ANTENNA ON CINDER BLOCK
You can mount the satellite antenna on cinder
blocks, whether they are part of a wall or the side
of a building.
¥ The surface must be flat and even.
¥ Be sure that the cinder block and mortar are in good condition.
¥ We recommend using toggle anchors and machine bolts, inserted into the hollow of the
block, as fasteners. Other types of anchors may not have the required strength.
MOUNTING THE ANTENNA ON THE ROOF
You can mount the satellite antenna on the roof.
This usually provides the highest available
location.
¥ Attach the satellite antenna to a rafter beneath the roof surface. You can locate the
rafter by looking for the nails attaching the fascia board to the rafters. You can also
locate the rafters from inside the attic.
¥ To prevent the roof from leaking, you should caulk the holes, or use silicone sealant
around the holes and at the bottom of the satellite antenna foot where it contacts the
surface. Apply the sealant before you bolt the foot down tight.
Page 1-12
Installation Guide
To Next Page
Loading...
Need help?
General
