Page 1-35
Installation and Setup
Installing The Receiver
STEP 4: INSTALLING THE RECEIVER
Connect the output of the satellite receiver to your TV as described in the Bell ExpressVu
User Manual, and turn on the Bell ExpressVu receiver. Use your new remote control to
carry out the following steps (the remote control operation is fully described in the User
Manual). Note that the Bell ExpressVu receivers are configured at the factory for English
language operation. French language operation is available after the dish is aligned and
the initial software download is complete.
See ÒWiring SetupsÓ in the Bell ExpressVu User Manual for suggested wiring
configurations.
1. Ensure your Smart Card is installed in the receiver. If your Smart Card came in a
separate package, you need to install it into the Smart Card slot in the receiver.
The receiver will work only with the correct Smart Card installed.
You must use the Smart Card that was provided with your receiver.
¥ Open the access door on the front panel
of the receiver by gently pulling on the
left edge.
¥ Unwrap the Smart Card, and insert it
with logo face up.
¥ Make sure the Smart Card is firmly
seated in the slot.
¥ Close the access door.
Note: Model 2700 receivers do not have an
access door.
2. Power on the receiver.
To Next Page
Loading...
Need help?
General
