EasyManua.ls Logo

Bella 14528 - Waffle Maker Operation; Identifying Components; Using the Waffle Maker; Locking and Unlocking

Bella 14528
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
Know your wafe maker
Product may vary slightly from illustration
Green Ready
Light
Green Ready
Light
Red Power
Light
Drip Tray*
Handle
* Drip tray included to collect overow of batter and crumbs.
To use the Wafe Maker
1. Plug the cord into your 110 - 120 V AC wall outlet. The Red Power Light will turn on indicating
theappliance is preheating.
NOTE: The Red Power Light will remain on until the appliance is unplugged.
2. The Green Ready Light will turn on when the appliance reaches proper cooking temperature.
Thisshould take approximately 3 to 5 minutes. Once heated, ready times will be faster.
3. When the Green Ready Light turns on, open the Wafe Maker, and apply a light layer of vegetable
oil or melted shortening to the heating plates. Spread the wafe batter evenly onto the lower
heating plate.
4. Close the Wafe Maker and rotate the handle 180º clockwise (right) until it locks for cooking.
5. When the Green Ready Light turns on again, rotate the handle 180º counter-clockwise (left)
tounlock and then carefully open the Wafe Maker.
6. If the wafes are not dark enough, close the Wafe Maker, rotate to lock, and then wait
another30seconds. Repeat as needed.
7. When you are satised with your wafes, use a non-metallic utensil to remove them from
theheating plates.
8. To make more wafes, close the Wafe Maker until the Green Ready Light comes on,
then repeat from step 3.
9. When you are nished, unplug it from the wall outlet. After it has sufciently cooled, the heating
plates may be wiped clean.
Locking and Unlocking your Wafe Maker
Your Wafe Maker is unlocked when the side with 2 indicator lights are facing up and is locked when
the2indicators lights are facing down. You can only open the Wafe Maker in the unlocked position.
Cleaning and Maintenance
1. Unplug it and allow it to cool down before cleaning.
2. You can easily remove any excess oils or crumbs without disassembling the appliance.
3. Never submerge the appliance in water or place it in the dishwasher.
4. Use only plastic or wooden utensils on the heating plates. Metal may damage the plates.
5. Use a soft cloth on the heating plates and occasionally a metal polish intended for stainless steel
onthe outer housing. Never use abrasive scouring pads or steel wool.
SO-312942_14528, 14531_BELLA_Rotating WM nonStick_WM US_IM_R4 (145x210mm).indd 6 2015-11-10 11:32 AM

Related product manuals