7
HINTS FOR CARE AND USE OF CERAMIC NON-STICK SURFACE
• To avoid scratching the ceramic non-stick surface, do not stack objects on the grill or griddle cooking plates.
CAUTION: DO NOT USE COOKING SPRAYS. THEY CAN CAUSE A BUILD-UP ON THE COOKING
PLATES AND MAY AFFECT THE CERAMIC NON-STICK PERFORMANCE OF THE PRODUCT.
• Use medium to low heat for best cooking results. Very high temperatures can cause discoloration and shorten
the life span of any ceramic non-stick surface. If higher temperatures are necessary, preheat on medium heat
for a few minutes.
• For best results and preserve the ceramic non-stick coating longer, use nylon, plastic, wooden or rubber
utensils. Never cut food on the Griddle.
• Remove stubborn stains with a plastic scouring pad and mild dish washing liquid; DO NOT USE STEEL WOOL
as it will damage the ceramic non-stick surface of the cooking plates.
STEPS FOR STAIN REMOVAL AND PROPER CARE OF YOUR CERAMIC NON-STICK COATING
1. Identify stained areas on the cooking surface and sprinkle some baking soda on the stains.
2. Moisten the baking soda to get a paste like texture by adding some water.
3. Let the paste stand for a few minutes on the stains (not more than an hour).
NOTE: Do not rub vigorously when using a plastic scouring pad and NEVER use a metal scouring pad
5. Repeat the cycle once again if necessary. The performance and non-stick property of the ceramic non-stick
STORING INSTRUCTIONS
1. Unplug and clean unit.
WARNING: Never store the unit while it is hot or plugged in.
(right button) on the back of the unit.
WARNING: Never wrap cord tightly around the unit. Never place any stress on the cord, especially where cord
enters the unit, as this could cause the cord to fray and break.
WARNING: Make sure to unroll cord storage before plugging it into the outlet.
4. Store in a clean, dry place.
Figure 3 Figure 4
35101_35140_35261_35262_Bella Fold and store griddle IM V7 R1.indd 735101_35140_35261_35262_Bella Fold and store griddle IM V7 R1.indd 7 2024-09-03 3:08 PM2024-09-03 3:08 PM
To Next Page
Loading...