3
3. Before leaving shore
ENG
Familiarise yourself with this owner's handbook.
Always check at least the following items before leaving shore:
Weather and forecast
Loading
Passengers
Fuel
Engine and equipment
Ventilation (only in gasoline-driven stern drive engine boats)
Fastening down objects
Nautical charts
Leaving the berth
Consider the wind, waves and visibility. Is the design category, size and equipment of your boat, as
well as the skills of the skipper and crew sufficient for the waters you are going to? In strong winds
and rough seas portholes, doors, hatches and vents must be closed to prevent water from getting
into/onto the boat.
Do not overload the craft, distribute loads suitably. For stability, do not place heavy loads high up.
Ensure that there are life jackets for everybody on board. Make sure all members of the crew
understand their specific tasks, before leaving shore.
Check that there is enough fuel, plus a reserve tank for bad weather etc.
Check the functioning and condition of steering, electrical equipment and batteries, and carry out
the routine checks specified in the engine instructions handbook. Check for seaworthiness
elsewhere: no leaks of fuel or water, safety equipment on board etc. Check that bilge water is at a
minimum.
Run the engine compartment fan for at least 4 minutes before starting the engine. Start the engine
following the instructions of the engine manufacturer. Ensure the ventilation of the fuel
compartments to reduce the risk of fire.
Make sure everything on board is properly secured even in the event of high winds and rough
seas.
If you are not navigating on totally familiar waters, ensure that you have nautical charts covering a
sufficiently large area.
The crew releases each mooring rope etc. as per your instructions. Make sure mooring ropes or
other ropes do not tangle with the propeller.
To Next Page
Loading...
