EasyManuals Logo

Bella Dots collection Instruction Manual

Bella Dots collection
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
7
PAUSE AND SERVE
1. After approximately 2 cups of coffee have been brewed, the carafe may be slowly
removed and the coffee will stop dripping.
2. The flow valve is located on the bottom of the filter holder and is activated when
the carafe is removed. This design makes it possible for you to remove
the carafe and pour a cup of coffee before the entire carafe is brewed.
IMPORTANT: When replacing the filter holder, the flow valve must be properly inserted
into the front hole of the machine, so that it can be seen as it sits on the top of the
carafe lid.
3. When using this feature, make sure that the carafe is replaced under the filter holder
within 30 seconds to prevent overflow.
BREWING A SECOND CARAFE OF COFFEE
1. To brew another carafe of coffee, press the BREW button to turn the Coffee Maker OFF.
Remove plug from wall outlet. It is recommended that the Coffee Maker be OFF and
allowed to cool for 15 minutes between cycles.
CAUTION: Failure to allow Coffee Maker to cool sufficiently could cause hot steam
and spray when the water is added to the water reservoir. The hot steam can cause
severe burns.
2. Lift the Coffee Maker lid. Unfold the handle, lift and remove the permanent coffee filter;
discard used coffee grounds, rinse in cool, clean water.
3. Lift the removable filter holder up and out of the Coffee Maker.
4. Rinse the glass carafe and removable filter holder in cool, clean water.
IMPORTANT: Before brewing a second carafe, always check to make sure water level is
past the MIN line; add the desired amount of cold tap water into the water reservoir.
5. Place empty carafe on the warming plate.
6. Place the permanent filter in the removable filter holder. Approximately 1 level tablespoon
is recommended for each cup of coffee desired
7. Drop the filter holder down into the housing. Close the lid.
8. Plug Coffee Maker into a 120V AC electrical wall outlet.
9. Press the BREW button. Brewing will begin.
HINTS FOR GREAT TASTING COFFEE
• AcleanCoffeeMakerisessentialformakinggreattastingcoffee.Regularcleaning,as
described in the Care & Cleaning Instructions and Descaling sections of this Instruction
Manual is highly recommended.
• Alwaysusefresh,coldwaterinyourCoffeeMaker.
• Finergrindspromotefullerextractionandproviderich,full-bodiedcoffee.Regulargrind
will require slightly more coffee per cup to provide the strength of a finer grind.
• Storecoffeeinacool,dryplace.Oncecoffeehasbeenopened,keepittightlysealedin
the refrigerator to maintain freshness.
• Foroptimumcoffeeflavor,buywholebeansandgrindthemfinelyjustbeforebrewing.
• Donotre-usecoffeegroundssincethiswillgreatlyimpaircoffeeflavor.
• Reheatingcoffeeisnotrecommended.Coffeeisatitspeakflavorimmediately
after brewing.
• Smalloildropletsonthesurfaceofbrewed,blackcoffeeareduetotheextractionofoil
from the coffee grounds. Oiliness may occur more frequently if heavily roasted coffees
are used. Over extraction may also cause oiliness, indicating a need to clean your
Coffee Maker.

Other manuals for Bella Dots collection

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bella Dots collection and is the answer not in the manual?

Bella Dots collection Specifications

General IconGeneral
BrandBella
ModelDots collection
CategoryCoffee Maker
LanguageEnglish

Related product manuals