4
ADDITIONAL IMPORTANT
SAFEGUARDS
1. All users of this appliance must read and understand this instruction guide
before operating or cleaning this appliance.
2. The cord to this appliance should be plugged into a 220V AC electrical outlet
only.
3. If this appliance begins to malfunction during use, immediately release
pressure on either cup (small grinding or tall blending) and unplug the cord. Do
not use or attempt to repair the malfunctioning appliance.
4. If this appliance falls or accidentally becomes immersed in water,
unplug it immediately. Do not reach into the water!
5. Do not use this appliance after it has fallen into or becomes immersed in water.
6. To reduce the risk of injury to persons or property, never use this appliance
in an unstable position.
7. Do not use this appliance for other than its intended use.
8. Do not use if either cup (blending cup or grinding) is cracked or chipped
9. IMPORTANT! This product is not an ice crusher. Always make sure to add at
least one cup liquid to the processing cup before adding ice or foods that are
frozen solid. Do not overll. Failure to add enough liquid before processing
may cause the processing cup to break or chip.
Notes on the Cord
The provided short power-supply cord (or detachable power-supply cord) should
be used to reduce the risk resulting from becoming entangled in or tripping over a
longer cord. Do not use an extension cord with this product.
Plasticizer Warning
CAUTION: To prevent Plasticizers from migrating from the nish of the counter top
or table top or other furniture, place NON-PLASTIC coasters or place mats between
the appliance and the nish of the counter top or table top. Failure to do so may
cause the nish to darken; permanent blemishes may occur or stains can appear.
Electric Power
If the electrical circuit is overloaded with other appliances, your appliance
may not operate properly. It should be operated on a separate electrical circuit
from other appliances.
Changing the Fitted/Moulded Plug
Should the need arise to change the tted/moulded plug, follow these instructions:
Mains (AC) Operation. This unit is designed to operate on 220V current only.
Connecting to other power sources may damage the unit.
Connect two-pin plug as follows:
The wires in this mainslead are coloured in accordance with
the following code:
Blue = Neutral
Brown = Live
To Next Page
Loading...
Need help?
General
