6. Hold the cup (tall or small) rmly in one hand. Use the other
hand to tighten the cup/blade assembly by turning the blade
collar clockwise until snug.
7. Plug the power cord into a 220V AC electrical outlet.
8. Invert the processing cup/blade assembly. Insert the blade
collar into the motor base, tting the tabs into the slots on
the motor base.
NOTE: The Rocket Blender will not operate unless the 3 locking
tabs on the processing cup are properly tted into the 3 slots on
the motor base.
9. To process, press down the processing cup (tall or small) and
turn it clockwise into the motor base until it is locked. To stop,
press down and turn counterclockwise the cup until the tabs are
fully aligned. Release the cup.
The blender will operate until pressure is released.
10. To pulse, simply press down. The motor will stop when you
release the cup. Check results and continue to pulse,
if necessary, until the desired consistency is reached.
WARNING: Do not operate the motor continuously for more than 1 minute at a time. Allow the motor to
rest for 3 minutes before continuing.
11. When processing is completed, turn the cup counter-clockwise in the base and lift to remove the
cup/blade assembly.
12. Invert the cup/blade assembly. Hold the cup (tall or small) rmly in one hand. Use the other hand to turn
the blade collar counter-clockwise and remove the blade from the processing cup.
13. Add the cup ring to enjoy fresh juice, blended drinks or smoothies immediately. Press down to fasten the
cup ring to any of the blending cups.
14. Unplug the Rocket Blender when not in use and before cleaning.
To Next Page
Loading...
Need help?
General
