24
Positioning the Appliance
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bowl or suitable
container that is held outside and lower than the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water inlet hose is not kinked or squashed.
The foll owing things shoul d be c hecked before star ting th e dishwashe r.
Syphon Connection
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run in to the sink, making sure to
avoid bending or crimping it. The top of the hose must be less than 1000mm.
The cont ent of t his manual i s very helpful to the users.
After installation, please make sure t o keep this manual .
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
1 Th e dish washer is level and fixed prope rly
2 Th e inle t valve is open
3 Th ere is a leakage at the connections of the co nduct s
4 Th e wires are tightly connected
5 Th e power is switche d on
6 Th e inle t and drain hoses a re kno tted
7 Al l packing ma terials and p rintings should be t aken out fro m the dishwasher
Position the a ppliance in the desired location. The back should rest against the wall behind it, and the sides,
along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can
be positioned either to the right or the left sides to facilitate proper installation.
Connect the cold water supply hose to a threa ded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been us ed for an extended period of time, let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water inle t to be blocked and damage th e appliance.
Please clo se the hydrant after using.
To Next Page
Loading...
