Belling BU LF609 - Shipment and Repositioning; Before Calling Your after Sales Service

EN -10-
SHIPMENT AND REPOSITIONINGPART 5.
Transportation and changing of installation position
• Original package and foam may be kept for re-transportation (optionally).
• You should fasten your fridge with thick package, bands or strong cords and follow the
instructions for transportation on the package for re-transportation.
• Remove movable parts (shelves,
accessories, vegetable bins etc.) or x them
into the fridge against shocks using bands
during re-positioning and transportation.
BEFORE CALLING YOUR AFTER SALES SERVICE
PART 6.
If your refrigerator is not working properly, it may be a minor problem, therefore check the
following.
The appliance does not operate,
Check if;
• There is a power failure,
• The mains plug is not properly plugged in, or is loose
• The thermostat setting is on position “ “,
• The socket is defective. To check this, plug in another appliance that you know which is
working into the same socket.
The appliance performs poorly;
Check if;
• You have overloaded the appliance,
• The door is not closed perfectly,
• There are not enough ventilation ducts in the kitchen unit as mentioned in the installation
manual.
If there is noise;
The cooling gas which circulates in the refrigerator circuit may make a slight noise (bubbling
sound) even when the compressor is not running. Do not worry, this is quite normal. If these
sounds are different check if;
• The appliance is installed rmly as described in the installation manual.
• Objects on the appliance are vibrating.