35
EN
Laundry remains wet at the end of the programme
• Excessive foam might have occurred and automatic foam absorption system might
have been activated due to too much detergent usage. >>> Use recommended
amount of detergent.
C
Machine does not switch to spinning step when the laundry is not evenly
distributed in the drum to prevent any damage to the machine and to its
surrounding environment. Laundry should be rearranged and re-spun.
A
If you cannot eliminate the problem although you follow the instructions in this section,
consult your dealer or the Authorized Service Agent. Never try to repair a nonfunctional
product yourself.
Machine does work. Nothing is displayed on the screen.
The plug might not be plugged in the
mains outlet.
Fuse may have blown.
Electricity may be cut off.
The “On/Off” button might have not
been pressed.
Check the plug.
Check the fuse.
Check the supply power.
Press this button.
The machine did not start after the program was selected and the «Start/Pause/
Cancel» button was pressed.
The front door may be ajar.
The Rinse Symbol amongst the Program Indicator Symbols is flashing. (Subject to the
model of your machine, water cut-off symbol may light up too)
Water may have been cut off.
You can restart your machine by pressing the
«Start/Pause/Cancel» button for a short time
after ensuring that the water is not cut off.
To Next Page
Loading...
