6
Installation
Warning
Electrical Shock Hazard!
Disconnect electrical power before
installing dishwasher.
Failure to do so can result in death or
electrical shock.
Positioning & Leveling
1. Take out the appliance from all packaging and check to ensure no damaged during transportation. If it
has been damaged, contact the retailer and do not proceed and further with the installation process.
2. Check the dishwasher by placing it so that its sides or back panel are in contact with the adjacent
cabinets or wall. It can also be recessed under a single work top.
3.
Place the dishwasher on a level and sturdy floor. If the floor is uneven, the front feet of the applianc
e
may be adjusted until it reaches a horizontal position (the lean angle must not exceed 2 degrees). The
maximum adjustable height of feet is 20mm. Proper placing horizontally can significantly reduce
vibrations or noise while it is running.
Connection Of Water And Electricity
Warning!
Connection to the water and electricity supplies should only be performed by a qualified technician.
The dishwasher should not stand on top of the water hoses or the electricity supply cable
The appliance must be connected to the water supply network using new piping. Do not use old piping.
Connection Of Water Inlet Hose
Connect the cold water supply hose to a
threaded 3/4(inch)connector and make sure that
it is fastened tightly in place. If the water pipes
are new or have not been used for an extended
period of time, let the water run to make sure the
water is clear and free of impurities. If this
precaution not taken, there is a risk that the
water inlet can get blocked and the appliance
could be damaged.
Ensure that the water inlet hose is not kinked or
squashed.
To Next Page
Loading...
