Bellini BTPRC250 - Troubleshooting Guide; Common Issues and Solutions

18
Troubleshooting
If your electric pressure cooker does not function properly or if the cooking quality is insufcient, consults
the table below. If you are unable to solve the problem, contact a quality personnel or consumer service
centre.
Symptom Possible reason
Solution
Appliance does not work Power plug not correctly connected
to wall outlet
Reconnect the power plug to
the wall outlet
Lid does not lock
Lid not correctly positioned Re-close the top lid
Floater valve stuck in up position Push oater valve down
manually.
Cannot open lid after the
appliance is depressurized
Floater valve stuck in up position Press the oater down with
chopsticks
Air / Steam escaping from
around the rim of the lid
The sealing ring is not well
assembled.
Make sure the sealing ring is well
assembled around the inner lid.
Food residue remaining on sealing
ring
Clean sealing ring
Sealing ring is damaged or worn out Replace sealing ring
Lid not locked properly Re-close the top lid
Air / Steam escaping from
around the oater valve
Food deposits stuck on gasket of the
oater valve
Clean the gasket of oater valve
The gasket of the Floater valve is
damaged or worn out
Replace the gasket
Floater valve does not rise
up after the appliance starts
pressurizing.
The pressure regulator valve is not in
CLOSE position
Rotate pressure regulator valve
to CLOSE position
Not enough food and liquid in the
inner pot
Check recipe for proper quantity
Air/ Steam escaping around the lid
rim and around pressure regulator
valve
Call Consumer Service Centre
1300 373 199
E1 appears on the display Sensor open circuit Call Consumer Service Centre
1300 373 199
E2 appears on the display Sensor short circuit Call Consumer Service Centre
1300 373 199
E4 appears on the display Pressure switch faulty Call Consumer Service Centre
1300 373 199