Bellini Crib - Page 12

12
Step 8 Diagram 9
HOW TO RAISE AND LOWER DROPSIDE:
To Raise:
Hold the dropside in the middle with one hand. Pull side up
firmly until it locks.
To Lower:
Hold the dropside in the middle with one hand. Pull side up
lightly but firmly and push lightly but firmly with knee towards
the center of the crib. Lower the side.
1
3
2
DIAGRAM 9
4
5
Y
6
STEP 7 Diagram 7
FITTING THE DROPSIDE
Position the dropside against the ends of the crib (1). At one
end insert screw X into hole W in the guide (2).
Press the other end outwards and repeat the procedure
descrived above. Slide the dropside downwards (3).
Diagram 8
Press the pin of screw Y (4), push the dropside inwards (5)
until the pin is inserted into the lower part of the guide.
DIAGRAM 7
DIAGRAM 8
1
3
X
W
2