Bellman BE1341 - Indicators and Signals; Sound; Flashing Light; Vibration

28
Indicators and Signals
Sound
TheBellmanAlarmClocksoundsanalarm.Thesoundvolumeis80dBAmaximumat1metre.
Themainfrequencyrangeis500-1000Hz.
ThesoundcanbeswitchedoffviatheSoundSwitch(7).
Flashing light
WhentheBellmanAlarmClockisactivated,4built-inashinglights(17)ashwitha
brightwhitelight.
TheashinglightcanbeswitchedoffviatheFlashSwitch(9).
Vibration
TheBellmanAlarmClockcanpowertwoBE1270BellmanBed-shakers(accessory)which
areplacedunderthepillowtowaketheuserupwhentheBellmanAlarmClockisactivated
TheBed-shakerisconnectedtothesockets(14).
Power supply
TheLED(1)isconstantlygreenwhenthepowersupplyunitisconnectedcorrectly.
WhentheLED(1)blinksgreen,theinternalback-upbatteryischarged,buttheAlarmClock
hasnoexternalpowersupply,eitherbecauseofapowerfailureorbecausethepowersupply
unitisnotconnected.
WhentheLED(1)blinksyellow,theback-upbatteryisnearlyatandtheAlarmClockhasno
externalpowersupply,eitherbecauseofapowerfailureorbecausethepowersupplyunitisnot
connected.Thebatterymustbechargedbyconnectingthepowersupplyunitandallowingthe
AlarmClocktochargeforatleast24hours.
Troubleshooting in brief
Symptom Solution
Nothinghappens. • Checkthatthepowersupplyunitisconnected
correctlyandthattheLED(1)isconstantly
green.
TheLED(1)blinks. • Checkthatthepowersupplyunitisconnected
correctly.
TheLEDsintheSnoozeButton(4)donotcome
onwhenthealarmclockisswitchedon.
• Checkthatthepowersupplyunitisconnected
correctly.
TheAlarmClockdoesnotemitanysoundsignals. • CheckthattheSoundSwitch(7)isintheON
position.
TheAlarmClockdoesnotemitanyashsignals. • CheckthattheFlashSwitch(9)isintheON
position.
ForfurtherinformationabouttheproductinEnglish,refertotheAppendix.