6
Start Using Camera
This camera uses 3 AAA batteries. For replacement of batteries, turn off the
power of the camera first.
Open the battery compartment cover, install batteries according to the prompt
marks for positive and negative polarities on the sides of the battery
compartment, and then close the battery compartment cover.
Install MicroSD memory card
Insert a MicroSD memory card into the memory card slot with the metal pins
facing the screen according to the prompt marks on the sides of the card slot.
To remove the memory card, press the memory card down until it pops up.
Before replacing the memory card, please turn off the
power of the video camera.
For card insertion, insert the card in the correct direction.
Do not apply excessive force onto the card when inserting
the card, to avoid damaging the card or the parts of the
video camera. If you cannot insert the card, please check
whether the card is inserted in correct the direction.
If a memory card is used the first time or a memory card
has been used in another video camera, please format the
memory card first.
Press the power key for 3 seconds and then release it; the camera is started up.
After startup, the camera will enter the photographing mode; you can press the
mode key to switch over between the photographing model, video recording
mode and the playback mode.
In the video recording mode, you can press the shutter key once to start video
recording, and press it again to stop video recording.
To Next Page
Loading...