5. Humidity: To activate the humidifying function press the “Cooler” button.
6. Swing
Press the “swing” button to activate and deactivate the oscillation function. The vertical direction of air ow can be adjusted manually by
directing the outlet louvers up and down.
7. Timer
Press the “Timer” button to set the fan running time between 1 and 7 hours, which switches the unit to standby after a pre-set time. Each
time the button is pressed, the time increases by 1 hours. For example, if you press the “Timer” button three times, the unit will run for 3
hours. 2H and 1H will light up in the control panel.
Operating the Water Tank
Check the water level in the tank frequently. Make sure that the water level does not fall below the “MIN” marking on the water tank.
Activating the cooling function with an insucient amount of water may cause the water pump to malfunction.
Before relling the water, switch o your unit and unplug the power cord.
When there is no water left in the tank, the unit will stop in order to prevent pump damage.
In order to increase the cooling eect of your fan, you can use freezer packs. Using ice packs reduces the temperature of the air ow, which
creates a more eective cooling eect. Make sure that the water level in the tank does not exceed the “MAX” level after the ice packs have
been put into the water tank.
Cleaning and Maintenance
After operating the cooler for long periods, the dust accumulated in the lter may aect the inow of air. Therefore, it is recommended to
clean the unit regularly. Please follow the steps below to clean your device.
Switch o the unit and unplug the power cord before doing any cleaning or maintenance.
1.Air lter:
To remove the air lter, rst remove the screws, then simply press the locks with both hands and pull it out. Use a neutral cleaning agent and
brush to clean the dust and dirt from the lter. To reattach the clean lter, place the lter bottom rst and then push the upper part until it is
locked tightly.
2. Curtain paper
After removing the air lter, you can see the curtain paper. Press the lock in the middle and gently pull out the pad. Use a soft brush to
remove the dust and dirt from the pad. Rinse it with water if necessary and leave it to dry in open air. Never use any chemical cleaning
solution that can harm the pad.
3. Water tank:
Remove the water tank and clean it with mild cleaning agents. Rinse with water.
4. Exterior Cleaning
Clean the exterior case, except for the control panel, with a soft, damp cloth. Never use abrasive cleaning agents that could damage the
case. Make sure that the unit is dry before operating it. Note: Never expose the control panel to water. Always clean it with a soft, dry cloth.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with
your local authority or retailer for recycling advice.
To Next Page
Loading...