Bematech Aquila S-100

Need help?

Do you have a question about the Bematech Aquila S-100 and is the answer not in the manual?

Summary

Interface Selection and Configuration Commands

Interface Selection Modes

Defines interface options: PC/AT, USB, and Wand Emulation for scanner connection.

Configuration Reset and Version Commands

Commands to reset parameters to default, discard changes, and show firmware version.

USB Interface Cable Notice

Important information regarding USB interface cables and compatibility for scanners.

Keyboard Wedge Mode Configuration

Message Terminator Settings

Configures message terminators for keyboard wedge mode, including None, Hor. Tab, Enter, Execute.

Keyboard Type Selection

Options for selecting keyboard layout: US, International (ALT), and IBM AT.

Capital Lock Settings

Controls for enabling or disabling the Capital Lock feature.

USB Mode Configuration

USB Mode Operation

Explains USB mode as a keyboard emulator for compatible operating systems.

USB Keyboard Type

Specifies keyboard types for USB mode: US Keyboard and International Keyboard.

USB Message Terminator

Defines message terminators for USB mode: None, Enter, H Tab.

Scanning Mode Selection

Options for scanner operation modes: Trigger, Auto Scan, Alternative, and Repeat Mode.

Good Read Beeper Settings

Good Read Beeper Tone

Configures the tone of the beeper for successful reads: High, Medium, Low, or Disable.

Good Read Beeper Duration

Sets the duration of the beeper sound: Long, Medium, Short, or Very Short.