Need help?Do you have a question about the Bematech I-500 and is the answer not in the manual?
Allows enabling or disabling the scanner's programming mode via specific barcodes.
Configure settings for EAN/UPC barcode symbologies, including supplemental codes and conversions.
Enable or disable the Code 128 barcode symbology and its character output.
Enable or disable the Code 39 barcode symbology and its character output.
Enable or disable the Code 93 barcode symbology.
Enable or disable the Code 32 barcode symbology.
Enable or disable the Code 11 barcode symbology.
Enable or disable the Codabar barcode symbology and its start/stop symbols.
Enable or disable the Interleaved 2 of 5 barcode symbology.
Enable or disable the Matrix 2 of 5 barcode symbology.
General| Type | Handheld bar code reader |
|---|---|
| Wavelength | 617 nm |
| Sensor type | LED |
| Scanner type | 1D/2D |
| Yaw reading angle | 0 - 360 ° |
| Tilt reading angle | -45 - 45 ° |
| Pitch reading angle | -35 - 35 ° |
| Linear (1D) barcodes supported | Codabar, Code 11, Code 128, Code 32, Code 39, Code 93, EAN-13, EAN-8, GS1 DataBar Omnidirectional, Interleaved 2 of 5, U.P.C. |
| Optical sensor resolution (W x H) | 640 x 480 pixels |
| 2D (matrix & stacked) barcodes supported | Aztec Code, Codablock, Data Matrix, MicroPDF417, PDF417, QR Code |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating temperature (T-T) | 20 - 50 °C |
| Operating relative humidity (H-H) | 5 - 98 % |
| Certification | EMC CE & FCC DOC, VCCI IEC 62471 |
| Product color | Black |
| Housing material | Plastic |
| International Protection (IP) code | IP54 |
| Input voltage | 5 V |
| Power consumption | 190 mA |
| Power source type | USB |
| Cable length | 1.4 m |
| Connectivity technology | Wired |
Weight and Dimensions| Depth | 121.6 mm |
|---|---|
| Width | 66.3 mm |
| Height | 162.8 mm |
| Weight | 200 g |
To Next Page
