Bematech I-500 - Suffix

I-500 Imaging Barcode Scanner
28
PROGRAMMING GUIDE
Suffix
Suffix is a character string output from scanner after sending out decoded barcode
information. It can be added by scanning the "Enable Suffix" setting code.
Enable Suffix Output
* Disable Suffix Output
Modify Suffix
Save Settings
The Suffix string can be modified by following steps:
1. Look up the hexadecimal codes of the prefix characters in the ASCII code character
table in Appendix A. Up to 15 characters is allowed in the Prefix string.
2. Confirm whether programming of scanner is enabled. If not, scan the "Enable
Programming” setup barcode on page 2.
3. Scan "Modify Suffix" barcode.
4. Scan the data setting bardcodes in Appendix B for the hexadecimal data codes of
the Prefix (2 hexadecimal digits per character).
5. Scan the "Save Settings" barcode.