9
User Instructions Continued
Manual control panel
200797_1
Use the ON / OFF switch to power on the heater (set it to standby mode).
In standby mode, the heater can be operated either manually by the switches located behind the fret
or by the supplied remote control.
Heater powered on, set to standby mode
Press to switch the flame effect ON
Press and hold to toggle between
different flame effect brightness levels
Press once to activate low level
heating(1000W)
Press twice to activate high level
heating(2000W)
Press three times to switch off heating
Press to toggle between 7 different fuel
bed effect colours
BACKLIGHT
Main
Power
Switch
Appliance Control
Panel
To Next Page
Loading...
