Benassi BL300 - Maintenance; Routine Engine and Chain Maintenance; Annual Greasing and Cleaning; Belt and Pin Replacement Procedures

SpA BL 300 /350
7
MAINTENANCE
• For the normal maintenance (oil, filter, spark plug) check the booklet for the engine included.
• The chain for the final transmission is lubricated with normal grease.
Every year you should introduce some grease through the hole “Q” (PICT 19) in the main body.
• Keep the machine and the tillers clean and check that all the screws and nuts are well tied, especially the screws of the tiller
(always wear protection gloves working on the tiller).
• In case of breaking or wear you can replace the belt after taking off the side protection cover fixed to the frame near the
engine shaft by two screws (PICT 12-13-14).
• In order to remove the belt of the reverse gear, it is necessary to remove the small cover (“K” PICT 14) by unscrewing its
screw. Remove the belt from the pulleys, install the new belt end adjust it following the instructions mentioned in the chapter
USE AND ADJUSTMENT by checking the distance between both sides of the belt, then replace the cover.
• The pin fixing the big pulley has also a safety purpose: in case heavy obstacle it will break avoiding damages to other parts of
the machine.
• The replacement of the pin is very easy: you have to insert the new pin in the hole using a hammer.
• For any technical repair especially during the guarantee period, it is recommendable to apply to the specialized workshops of
our dealers.
CAUTION
It is advised not to keep the motor running when the machine is not being used for its
specific purpose
-PICT n°19-
WARRANTY
Our machines and accessories are guaranteed for 2 years excluding electric and rubber parts.
All the defective parts will be replaced free of charge excluding cost of labour and transport freight, which would be at customer’s
charge.
For any problem regarding the engine or any other part not of our production, please refer to the guarantee conditions stated by
the manufacturer and apply to their assistance centres.
For any kind of problem or repair please apply to the dealer where you bought the machine.