SpA F 170
6
SAFETY DEVICE FOR STOPPING THE MOTOR
The main f unction of the lev er Fig. 7 is to turn off the motor when releasing y our hands f rom the steering handles.
Every time you get ready to start the motor, check if the engaging and disengaging of the transmission to the wheels
and to the bar through the levers on the handlebars work regularly .
-Fig. n°6-
-Fig. n°7-
OPERATING AND REGULATING THE MACHINE
Before y ou start mowing, oil the cutting blade, then start the motor as f ollows:
• Engaging the transmission to the wheels and the cutting bar by means of the clutch lev er must be carried out with
the motor at a middle r.p.m. and by slowly releasing the lev er.
• When starting to mow, position the accelerator lev er at 3/4 or at "MAX" to ensure adequate power.
• When mowing along a wall or the edge of a sidewalk, be careful to keep a saf ety distance so that the blade does not
suff er impact. If not, the cutting bar may undergo damage.
• If the belt slips, loosen the register located on the clutch lev er and leav e a trav el of approximately 5 mm bef ore the
clutch engagement.
• Adjusting the height of the handles is carried out by moving the knobs securing them on the handlebar support. This
will allow two positions (Fig. 1 Ref . 10).
• To regulate the motor, read the manual on the motor under "REGULATIONS".
-Fig. n°8- -Fig. n°9-
To Next Page
Loading...