FIG.1
3
2
11
COMPONENTS
MOTOR
Be sure your power supply matches with the nameplate marking. Voltage decrease
of more than 10% will cause loss of power and overheating. These tools are factory
tested; if this tool does not operate, check power supply.
Refer to page 9 of this manual for a complete list of components.
INTENDED USE
DO NOT use under wet conditions or in presence of flammable liquids or gases.
DO NOT let children come into contact with the tool. Supervision is required when
inexperienced operators use this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal injury, turn unit o and
disconnect it from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
WARNING: Shock hazard. Under no circumstances should this product be
used near water.
WARNING: Risk of lacerations or burns. Do not touch work piece or accessory
immediately after operating the tool. They can become very hot. Handle carefully.
Always allow accessories and work piece to cool before handling.
INSTALL & REMOVING THE SOCKETS
CAUTION:
Use only impact sockets. Non-impact sockets may break and cause a hazardous
condition. Inspect socket prior to use to ensure that it contains no cracks.
To install an accessory, firmly push accessory onto the 1/2” hog ring anvil (2). The
hog ring (3) compresses to allow the accessory to slide on. After the accessory is
installed, the hog ring applies pressure to help provide accessory retention. (FIG.1)
To Next Page
Loading...