1248-000
1/2" DRIVE IMPACT WRENCH
10
ASSEMBLY AND ADJUSTMENTS
REMOVE ACCESSORY
To remove an accessory, grasp the accessory and firmly pull it out of the
1/2" hog ring anvil.
OPERATION
WARNING:
disconnect it from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
WARNING: Shock hazard. Under no circumstances should this product be
used near water.
WARNING: Risk of lacerations or burns. Do not touch work piece or accessory
immediately after operating the tool. They can become very hot. Handle carefully.
Always allow accessories and work piece to cool before handling.
PROPER HAND POSITION
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden reaction.
Proper hand position requires one hand on the handle. (Fig. 2)
ON/OFF SWITCH
1. Press the bottom part of the forward/reverse switch marked “F” to run the tool
in a forward (right-hand thread) direction. (FIG.3)
2. Press the top of the forward/reverse switch marked “R” to reverse the motor
direction. (FIG.3)
FIG.2 FIG.3
To Next Page
Loading...