19
209CC PRESSURE WASHER, 3200 PSI
OWNER'S MANUAL
RISK OF FIRE CLEARANCES
WARNING Exhaust heat/gases could ignite combustibles, structures or
damage fuel tank causing a fire, resulting in death or serious injury.
• Keep at least 5 ft. (1.5 m) clearance on all sides of pressure washer including
overhead.
TO START YOUR PRESSURE WASHER
To start your engine-powered pressure washer for the first time, follow these instructions
step-by-step. This starting information also applies whenever you start the engine after
you have let the pressure washer sit idle for at least a day.
1. Place pressure washer outside near a water source capable of supplying water at a
flow rate greater than 3.7 gallons per minute and no less than 20 PSI at pressure washer
end of garden hose.
2. Check that high pressure hose is tightly connected to spray gun and pump. See
“Assembly” for illustrations.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure washer pump.
CAUTION! Do Not run the pump without the water supply connected and turned on.
• Damage to pressure washer resulting from failure to follow this instruction will void
warranty.
5.Turn ON the water, point the spray gun at a safe direction, release the grey trigger
lock, then squeeze trigger to purge the pump system of air and impurities. See
"Assembly".
6. Attach the spray wand into spray gun. Tighten by hand. See "Assembly" .
7. Choose the quick-connect nozzle you want to
use, pull back on collar of spray wand, insert the
nozzle and release collar. Tug on the nozzle to make
sure it is securely in place. See "Assembly".
More
information please see “How to Use Quick-Connect
Nozzles” section
.
8. Engage the Grey trigger lock on the spray
gun.
9. Push engine rocker switch to ON position.
NOTICE: Before starting the pressure washer, be sure you are wearing safety goggles
as described below.
Off
On
WARNING! Risk of eye injury.
Spray could splash back or propel objects resulting in serious injury.
• Always wear indirect vented (chemical splash) safety goggles marked to
comply with ANSI Z87.1 when using or in vicinity of this equipment.
• NEVER substitute safety glasses or dry-condition goggles for indirect vented safety
goggles.
To Next Page
Loading...
