31
5140-011
212CC/4-CYCLE GAS REAR TINE TILLER
WARNING
Do not attach spark plug wire to spark plug when storing the unit.
4. Clean tiller. Remove all dirt, leaves, debris, grease, etc. from the tiller —
including cylinder cooling fans, recoil starter cover holes, under fuel tank, and
under muer.
5. Check the tiller for worn or damaged parts. Have damaged parts replaced if
necessary.
6. Tighten any loose hardware.
7. Apply lubrication as directed in Maintenance section.
8. Put the unit in a building that has good ventilation.
9. Cover the tiller with a breathing material.
TRANSPORTING THE TILLER
Empty the gas tank. Always let the engine run until it has used up the remainder of
gas in the tank. Empty the engine oil from the warm engine. Remove the spark plug
cover from the spark plug. Clean the cooling fins of the cylinder and the housing.
Use the original packaging to ship whenever possible.
To Next Page
